Motorola DVR530 Operation & User’s Manual

Text of the manual

Graphical symbols and supplemental warning marking locations on bottom of

terminal. WARNING: “DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE.” To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. Do not open the unit. Refer servicing to qualified personnel only.

Read instructions. The safety and operating

instructions should be read before the appliance is operated. Retain instructions. The safety and operating instructions should be retained for future reference. Heed warning. Pay attention to all warnings on the equipment operating instructions. Follow instructions. All operating an

Programming Copyright Notice

Use of this device may violate Section 605 of the Communications Act of 1934, as amended, if that use consists of the unauthorized interception and divulgence of radio communications for one’s own benefit where there is no entitlement to its receipt. Changes or modifications to this device not expressly approved by the party

information must be provided to the telephone company.

The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive REN’s on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the REN’s should not exceed five (5.0). To be certai

This consumer unit is intended for the decoding of DigiCipher® II television signals for consumer use. Possession of this device does not enable or entitle the

possessor to receive DigiCipher II television signals. Contact program providers to obtain appropriate authorization. WARNING The unauthorized modification of any decoder and the sale and

DVR Basics .............................................................................................................. 8

Connecting Your DVR ........................................................................................... 10 Menu Navigation ..............................................................................................

1. ON/OFF Alternates between ON and STANDBY modes.

2. SIGNAL LED Green indicates a good satellite signal. Red indicates no signal. 3. REMOTE LED Flashes to acknowledge a command from the remote control. 4. CLOCK Indicates the current time or channel number. 5. MAIL LED Indicates an unread message in the mailbox. 6. TIMER LED A steady light indicates a tim

13. POWER CORD

14. ANTENNA INPUT For analog off-air broadcast antenna. 15. CH3/4 SWITCH To set the RF output to channel 3 or 4. 16. RF OUTPUT 17. COMPOSITE VIDEO OUTPUTS 18. COMPONENT VIDEO OUTPUT (Y Pb Pr) 19. OPTICAL DIGITAL AUDIO OUTPUT 20. UHF REMOTE CONTROL ANTENNA PORT 23 21 22 13 14 15 16 19 20 24 25 27 26 18 21. TELCO PHONE JACK For Instant Pay-

Connecting Your DVR

Make sure that the satellite receiver is not plugged into a power source before you connect any cables to the receiver. First connect the satellite input from your satellite dish to your receiver. There are several way to connect your DVR to your television or monitor and other home theater components. Video: Utilize the modulated RF o

Other DVR Manuals