HP Xw8200 - Workstation - 1 GB RAM Installation Instructions Manual

HP Workstations This document describes how to prepare select HP workstations for installation into a fixed rack. Kit Contents The following components are included in your fixed rack kit: Å WARNING: Metallic particulates can be especially harmful around electronic equipment. This type of contamination may enter the data center ...

■ HP Series-E Rack ■ Compaq Rack ■ Many third-party racks, including those with pre-threaded columns NOTE: Each type of rack requires different hardware and tools. Notes in this document identify those differences. Overview To mount your tower system in a rack, you must: 1. Co ...

1. Install the rails on your rack. ❏ Compaq Rack: Use M6 hardware and follow the rail installation instructions. ❏ HP Series-E rack: Use M5 hardware and follow the rail installation instructions. (M6 screws are required to attach the rails to the front columns of this type of rack.) ❏ Rack with pre-threaded columns: Use the rail adap ...

Å WARNING: Never remove the system access panels without first turning the system off and unplugging the power cord from the outlet or Power Protection Device. 1. Turn off the system and disconnect the power cable and all other cables from the back of the system. 2. Remove the side access panel from the chassis: a. I ...

5. Using a screwdriver, push gently through the opening on the top of the chassis to release the top panel. 6. While continuing to push the release button, grasp the top panel and slide it toward the back of the system. 7. Lift the plastic panel off of the system chas ...

a. Lower the access panel onto the chassis (aligning the guide rail on the bottom inside edge of the access panel with the bottom edge of the workstation chassis). b. Close the access panel, ensuring that the guides on the top of the access panel slide into the rails at the top of the chassis. 9. If desired, lock the acces ...

1. Place the workstation on the rails and slide it into the rack: a. Holding the workstation with both hands to support its weight, set the workstation on the rails. b. After the workstation is securely seated on the rails, push the workstation to slide it all the way into the rack. ...

On an HP or Compaq rack: a. Attach M5 or M6 clipnuts as shown: b. Attach the bracket to the rack using the appropriate hardware for your rack. NOTE: On a rack with pre-threaded columns, the screws attach directly to the column. 3. Attach the trim piece and warnin ...

9 固定ラック キットのインストール HP Workstation 本書では、お使いのHP ワークステーションを固定ラックにインストールするための準備の方 法を説明します。 キットの内容 固定ラック キットには、以下のコンポーネントが含まれています。 Å 警告: 金属微粒子は、電� ...

■ Compaq 製ラック ■ あらかじめカラムが取り付けられているサード パーティ製のラック 注記: 各種ラックによって必要となるハードウェアとツ ...