Hunter 21325 Owner's Manual And Installation Manual

Type 2 Models Type 2 Models Form# 45037-01 20110606 ©2011 Hunter Fan Co. For Your Records and Warranty Assistance For reference, also attach your receipt or a copy of your receipt to the manual. __________________________________________ Model Name __________________________________________ Model No. __________________________________________ ...

Table Of Contents 1 • Getting Ready . . . . . . . . . . . . . . . . . . . . . . 6 2 • Installing the Hanger Bracket . . . . . . . . 7 3 • Assembling and Hanging the Fan . . . . 8 4 •Wiring the Fan . . . . . . . . . . . . . . . . . . . . . . 10 5 • I ...

Preparing the Fan Site 7’ Minimum Blades to Floor 8’ Minimum Ceiling Height 30” From Wall or Nearest Obstruction Step 1 - Choose the Fan Site Proper ceiling fan location and attachment to the building structure are essential for safety, reliable operation, maximum efficiency, and energy savings. Choose ...

Preparing the Fan Site (continued) CAUTION: All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. Steps 2 – 3 Step 4 Step 5 Step 2 - Cut the Ceiling Hole 2-1. Locate the site for the ceiling hole directly ...

Installer’s Choice and Optional Accessories Understanding Mounting and Installer’s Choice® Hunter’s patented 3-position mounting system provides you maximum installation flexibility and ease. You can install your Hunter fan in one of three ways, depending on ceiling height and your preference: Low Pro ...

To install a ceiling fan, be sure you can do the following: • Locate the ceiling joist or other suitable support in ceiling. • Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you ...

2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box. The pilot holes should be 9/64” in diameter. Note: Your fan comes with four pre-installed neoprene noise isolators. 2-2. Thread the lead wires from the outlet box down through the hole in the mid ...

You can assemble your fan for standard or angled mounting as shown in steps 3-1 – 3-3. For low profile mounting (ceilings less than 8 feet high), go to steps 3-6 – 3-9 on the next page. 3-1. To assemble fan to hang down from a flat or angled ceiling, place the canopy and canopy trim ring around the adap ...

3 • Assembling and Hanging the Fan (Low Profile Only) You can assemble your fan for standard or angled mounting as shown in steps 3-1 – 3-3 on the previous page. For low profile mounting (ceilings less than 8 feet high), see steps 3-6 – 3-10 on this page. 3-6. Remove the screws from the hanger ball b ...

All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes. 4-1. Before attempting ...