Icom IC-450 Instruction Manual

may damaged the radio and may also cause you to exceed FCC RF exposure limits. A proper antenna is the antenna supplied with this radio by the manufacturer or antenna specifically authorized by the manufacturer for use w ...

is very close to, or touching exposed parts of the body, especially the face or eyes, while transmitting. The transceiver will perform best if the microphone is 5 to 10 cm (2 to 4 inches) away from the lips and the transceiver is vertical. R WARNING! NEVER operate the ...

………………………………………… 35–44 ‘ Battery charging …………………………………………………… 35 ‘ Caution ……………………………………………………………… 36 ‘ Optional battery chargers …� ...

Attach the jack cover when the optional speaker-microphone is not used. D Belt clip Attach the belt clip to the back of the transceiver with the supplied screws. Supplied screws q w e r To attach the jack cover: q Insert the jack cover into the [SP MIC] connector. w Tighten the screw. To detach the jack cover: e Un ...

Turns power ON and adjusts the audio level. w RED BUTTON The desired function can be assigned by your dealer. e ANTENNA CONNECTOR Connects the supplied antenna. r SPEAKER-MICROPHONE CONNECTOR [SP MIC] Connects the optional speaker-microphone. (p. 46) t DEALER-PROGRAMMABLE KEYS [P0] to [P3] The desired fu ...

q OUTPUT POWER INDICATOR Appears when Low 2 or Low 1 is selected. w AUDIBLE INDICATOR ➥Appears when the channel is in the ‘audible’ (unmute) condi- tion. ➥Appears when the specified 2/5-tone/BIIS code is received. e COMPANDER INDICATOR Appears when the compander function is activated. r KEY LOCK INDICATO ...

➥Push to select Priority A or Priority B channel. ➥Push and hold [Prio A (Rewrite)] to rewrite the Prio A channel. MR-CH 1/2/3/4 KEYS Select an operating channel directly. MONITOR KEY ➥Mute and release the CTCSS (DTCS) or 2-tone squelch mute. Open any squelch/deactivate any mute while ...

➥When [Emergency Single (Silent)] or [Emergency Repeat (Silent)] is pushed, an emergency call is transmitted without a beep emission and LCD indication change. • If you want to cancel the emergency call, push (or push and hold) the key again ...

q Rotate [VOL] to turn power ON. w If the transceiver is programmed for a start up passcode, input digit codes as directed by your dealer. • The keys in the table below can be used for password input: • The transceiver detects numbers in the same block as identical. Therefore “01234 ...