IKEA MÖJLIG Operation & User’s Manual

6 Care and cleaning 6 What to do if… 7 Technical data 7 Installation 8 Environment concerns 11 IKEA GUARANTEE 12 Subject to change without notice. Safety information For your safety and correct operation of the appliance, read this manual carefully before inst ...

they are built into suitable built-in units and work surfaces that meet standards. • Do not change the specifications or modi- fy this product. Risk of injury and damage to the appliance. Warning! Carefully obey the instructions for electrical and gas connections. • Do not install the appliance if it is dam- ...

this will allow thermocouple to heat up, and the safety device to switch off, oth- erwise the gas supply would be inter- rupted. 3. After the flame is regular, adjust it as preferred. If after a few attempts the burner does not ignite, check that the crown and its cap are in correct positions. 1 2 3 4 5 1 Burner cap 2 ...

clean the appliance with steam blasters or high-pressure cleaners. Warning! Do not use abrasive cleaners, steel wool pads or acids, they will damage the appliance. To remove any food remains wash the enamelled elements, "caps" and "crowns", with warm soapy water. Stainless steel elements wash with water, and then dry with ...

Appliance Category: II2H3B/P (AT) / II2E3B/P (DE) Appliance gas supply: Natural gas G20 (2H) 20 mbar (AT) Natural gas G20 (2E) 20 mbar (DE) This appliance is designed for use with nat- ural gas but can be converted for use with other gas type according to table below. Type of Gas Burner type Injectors 1/100 mm Nominal Power kW Nominal Flow ...

tions (nature of the gas and gas pres- sure) and the adjustment of the appliance are compatible before proceeding with the installation. The parameters of adjustment setting for this appliance are stated on the rating plate (refer to the Technical data chapter). Warning! The appliance must be earthed! Warning! Risk o ...

If connecting the appliance directly to the electric system, it is necessary that you in- stall a double pole switch between the ap- pliance and the electricity supply, with a minimum gap of 3 mm between the switch contacts. The double pole has to be of a type suitable for the required load in com- pliance with t ...