JBL PSW-D112 Service Manual

Text of the manual

JBL Consumer Products Inc.

250 Crossways Park Drive Woodbury, N.Y. 11797 1-800-336-4JBL in the USA A Harman International Company Rev E 7/2001 PSW-D112/DPS-12 Powered Subwoofer SERVICE MANUAL

List of Safety Components Requiring

Exact Replacements (all parts POWER AMP PCB except TR2) C6 (Rev0) 4.7uf 100V 80/-20% Electrolytic redial NP C6 (Rev1) 4.7uf 100V 80/-20% Electrolytic redial NP TR2 MPS A13 30V NPN(Darl) R4a/b/c 0.1 0.5W 5% metal film R9 3.3 5W 5% ceramic wirewound R15 100k 0.5W 5%

TABLE OF CONTENTS

SAFETY INFORMATION .......................................................2 TABLE OF CONTENTS.........................................................3 GENERAL SPECIFICATIONS ...............................................3 DETAILED SPECIFICATIONS...............................................4 CONTROLS

Normal operation, MOMS required

Parameter Specification Unit Test Limits Conditions Notes Amp Section Type (Class AB, D, other) D n/a Class D Preferred...Sink required for Class AB Load Impedance (

THD at Max. Output Power

10 % functional ck. Maximum Output Power Maximum THD as a result of limiting. Features Phase Switch (yes/no) YES — functional ck. Volume pot Taper (lin/log) LOG — functional ck. Input Configuration — Line In (L,C,R,AC3,Mono) L,R,C — functional ck.. Enabled w/Line/Spkr Input Select Switch Line Outputs (L,C

1. Power LED - Will illuminate when the unit is turned on

with the main power switch. This light will be RED when the unit is plugged in and not receiving a signal; when the PSW-D112 receives a signal, the light will cycle to GREEN. If no signal is received after 10 – 15 minutes the light will cycle back to RED (standby) until a signal is present again. 2.

If you hooked up your subwoofer as shown in Speaker

Connection 4 on page 9. you also have the capability of adjusting the high-pass frequency. The High-Pass control determines the frequency at which the main speaker will start reproducing sounds. If your main speakers can comfortably reproduce some low-freque

1) If your receiver/amplifier has no

subwoofer outputs or preamp outputs for the left, center and right channels. See Figure 1. 2) If your receiver/amplifier has subwoofer outputs or preamp output jacks for the left and right channels. See Figure 2. 8 Amplifier/Subwoofer PSW-D112/DPS-12 NOTE: The rear plate for the PSW-D112 is shown, whic

3a) If your receiver/amplifier has a single

(mono) subwoofer output or LFE output, connect the output using a “Y”-connector (not included) to both Left or Right line-level inputs on the subwoofer. Plug the single male end of the “Y” connector into the receiver/amplifier, and connect the 2 interconnect cables to the Left and Right line-level inputs on

Other Subwoofer Manuals