JBL PS100 Owner's Manual

DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE AMPLIFIER BACK. NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" ...

loudspeakers. Their highly accurate, uncolored and balanced sound character will greatly increase your enjoyment of recorded music. We build JBL speakers with careful attention to detail, using only the highest quality materials. They will provide many years of excellent performance. Our PS Series rivals the per ...

amplifier)" - Use these inputs when connecting to the speaker out (speaker mains) of your receiver/T.V./source amplifier. Run speaker wires from the speaker output terminals (usually coded red and black) on the rear of your receiver/T.V./source amplifier to the red and black input terminals labeled "Speaker Level Input (from amplif ...

(to external speakers) + R + R L + L + L R Crossover Frequency Level Min Max 50 200 (Hz) Polarity Reverse Normal Speaker Level Input (from amplifier) Line Input PS Subwoofer L R + - + - Receiver, TV, or Amplifie L R FIG. 1: Line Level Input Connectio RCA Phono Cables ...

(to external speakers) + R + R L + L + L R Crossover Frequency Level Min Max 50 200 (Hz) Polarity Reverse Normal Speaker Level Input (from amplifier) Line Input PS Subwoofer L R + - + - Receiver, TV, or Amplifie L R FIG. 2: Speaker Level Input Connecti Speaker Wire ...

amplifier to produce the low bass while passing the unaltered signal source to the external speakers. "Speaker Level Output (to external speakers)" - Hook up the external speakers using two- conductor insulated wire following the same procedure described under Speaker Level Input. Connect the red (+) terminal of the PS subwoofer t ...

(to external speakers) + R + R L + L + L R Crossover Frequency Level Min Max 50 200 (Hz) Polarity Reverse Normal Speaker Level Input (from amplifier) Line Input PS Subwoofer L R - + + - Receiver, TV, or Amplifie L R FIG. 3: Speaker Level Output Connecti External Speakers + - - + Speaker Wire 8 ...

green. After approximately 3 minutes of non-use (no signal being received), your PS subwoofer goes into the auto shut- off mode. The LED turns RED to signify this stand-by condition. AMBER - The LED turns amber briefly when the amplifier is in the protection mode. This occurs when the subwoofer power switch is turned on while ...

maintain proper acoustic summation with the main speakers. Listen to your PS subwoofer and main speakers with the switch on "Normal" then listen to the same material with the switch on "Reverse". Decide which way sounds better and leave the switch in this position. You should repeat this procedure if you move your PS subwoofer to a ...