JUNO JVZ9491 Operating Instructions Manual
Text of JUNO JVZ9491 Operating Instructions Manual
Cleaning the inside.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.page
19
Electrical co
It is most important that this instruction book
should be retained with the appliance for future
reference. Should the appliance be sold or trans-
ferred to another owner, or should you move house
and leave the appliance, always ensure that the
book is supplied with the appliance in order that
the new owner can be acquainted with the func-
tionin
If this new appliance, fitted with a magnetic door
seal, is replacing an older one which has a me-
chanical closing or locking device, you are advised
to render these devices inoperable before discard-
ing the appliance. This is to avoid the possibility of
children accidentally shutting themselves in the
appliance and thus endangering their
The height of the appliance is adjustable from 820 to
870 mm (Fig. 1) to line up with existing kitchen units.
Fig. 1
Before installing the appliance between units, adjust
the height of the feet and rear wheels.
The wheels are factory set for a height of 820 mm. To
align the appliance to a height of 870 mm, raise it by
adjusti
Fitting the door panels
ª Drill the door panels as shown in the diagram and fit
the guide blocks (Fig. 5).
Fig. 5
ª Carefully level the appliance before fitting the door
panels.
ª Open one of the two bottom doors and its hinge
and insert the door panel through guide block A in
the guide on the appliance door.
ª Secure the panel with a screw in the v
ª Fix the door panel to the top hinge with a screw in
the vertical slot.
ª Fit bottom guide block G using two screws and fix
the hinge with the screw in the vertical slot (Fig. 9).
ª Repeat these operations for the other top door.
Check the horizontal alignment of the door panels
and adjust if necessary (Fig. 10).
ª Re-open the door and drill