JVC KD-G401 Instructions Manual

Für den Einbau und die Anschlüsse siehe das eigenständige Handbuch. Pour l’installation et les raccordements, se référer au manuel séparé. Bijzonderheden over de ins ...

While holding SEL (select), press (standby/on attenuator) for more than 2 seconds. This will reset the built-in microcomputer. Notes: • Your preset adjustments—such as preset channels or sound adjustments—will also be erased. • If a disc is in the unit, it will eject when you reset the unit. Be careful not to drop th ...

to ensure your complete understanding and to obtain the best possible performance from the unit. How to reset your unit ............................... 2 How to use the MODE button ................... 2 LOCATION OF THE BUTTONS ............ 4 Co ...

Control panel 1 (standby/on attenuator) button 2 SEL (select) button 3 FM/AM button 4 CD button 5 Loading slot 6 Display window 7 0 (eject) button 8 TP PTY (traffic programme/programme type) button 9 Remote sensor • You can control this unit with an optionally purchased remote controller. p 5 (up) button +10 button q Contr ...

1 Turn on the power. Note on One-Touch Operation: When you select a source in step 2 below, the power automatically comes on. You do not have to press this button to turn on the power. 2 Select the source. To operate the tuner (FM or AM), see pages 8 – 18. To play a CD, see pages 19 – 22. To play an MP3 dis ...

demonstration When shipped from the factory, display demonstration has been activated, and starts automatically when no operations are done for about 20 seconds. • It is recommended to cancel the display demonstration before you use the unit for the first time. To cancel the display demonstration, follow the procedure below: ...

You can also set the clock system to either 24 hours or 12 hours. 1 Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display. (PSM: see page 31.) 2 Set the hour. 1 Select “CLOCK H” (hour) if not shown on the display. 2 Adjust the hour. 1 2 3 Set the minute. 1 Select “CLOCK M” ...

You can use either automatic searching or manual searching to tune in to a particular station. Searching for a station automatically: Auto search 1 Select the band (FM1 – 3, AM). Each time you press the button, the band changes as follows: Note: This receiver has three FM bands (FM1, FM2, FM3). You can use ...

Manual search 1 Select the band (FM1 – 3, AM). Each time you press the button, the band changes as follows: Note: This receiver has three FM bands (FM1, FM2, FM3). You can use any one of them to listen to an FM broadcast. 2 Press and hold ¢ or 4 until “M” (manual) starts flashing on the display. 3 Tune in ...

To tune in to stations of higher frequencies Storing stations in memory You can use one of the following two methods to store broadcasting stations in memory. • Automatic preset of FM stations: SSM (Strong- station Sequential Memory) • Manual preset of both FM and AM stations FM station automatic pre ...