AMT Datasouth Fastmark M5 Plus Series Operation & User’s Manual

2.1 Unpacking and Inspection....................................................................1 2.2 Equipment Checklist ................ ...

Although the printer takes only a small amount of space, it delivers reliable, superior performance. This printer provides direct thermal printing at user selectable speeds of: 2.0, 3.0, 4.0 or 5.0 inches per second. It accepts roll feed, die-cut, and fan ...

„ Guillotine cutter Full cut: Paper thickness: 0.06~ 0.19mm, 500,000 cuts Partial cut: Paper thickness: 0.06~0.12mm, 500,000 cuts Paper thickness: 0.19mm 200,000 cuts „ Main board integrated with internal Ethernet „ Internal Ethernet print server module Accessories „ KP-200 „ KU-007 plus „ External ...

2.3.1 Front View Fig.1 Top Front View 2.3.2 Rear View 3 Setup 3.1 Setting Up the Printer 1. Place the printer on a flat, secure surface. 2. Make sure the power switch is off. 1 2 3 4 5 6 1. USB Interface 2. Centronics Interface 3. RS-232C DB-9 Interface 4. Power Jack 5. Power Switch 6. Rear Label Guide Top Cover Open Lever LED Indicator F ...

4 Plug the DC power cord into the power jack at the rear of the printer, and then plug the AC power cord into a properly grounded receptacle. Fig. 5 Attach a power supply to a printer 3.2 Loading Media Stock 1. Insert spindle into a media roll (If your media core is 1 inch, remove the ...

printer and lifting the top cover. 3. Place a roll of media onto the internal Media Spindle. 4. Feed the media (printing side face up) under the Teflon bar and through the support guides. The media should come to rest outside the printer. Refer to Fig #7 ...

1. Open the top cover. 2. Remove the 6 screws in the lower inner cover. 3. Turn over the printer. 4. Remove two screws located near the top cover hinge. Remove screw Remove screw Screws Screws ...

6. Separate the top, inner, and the lower cover. 7. Thread the cable red connector through the inner cover opening located near the front of the printer. Insert the red cable connector into location JP17 (M5 DT) / JP19 (M5 DT PLUS) on the main board. Install the peel-off module onto the lower inner cover slot. Lowe ...

9. Reassemble parts in reverse procedures after installing the module. Peel-off module assembly Install (2-places) one side at a time. ...