JVC RX-6510VBK Instructions Manual

Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Model No. Serial No. LVT0578-007A [C] INSTRUCTIONS MANUAL D’INSTRUCTIONS ADJUST RX-6510V AUDIO/VIDEO CONTROL RECEIVER SETTING MASTER VOLUME CONTROL DOWN UP BASS BOOST INPUT ANALOG/DIG ...

Mises en garde, précautions et indications diverses CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash wit ...

Mur, ou obstruction Stand height 15 cm or more Hauteur du socle: 15 cm ou plus Front Avant RX-6510VBK Spacing 15 cm or more Dégagement de 15 cm ou plus For Canada/pour Le Canada THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STAN ...

Parts Identification ...................................... 2 Getting Started........................................... 3 Before Installation ...................................................................... 3 Checking the Supplied Accessories ........................................... 3 Connecting the FM and AM Antennas .. ...

Refer to the pages in parentheses for details. 6 1 2 3 4 5 7 q 9 8 i u e r w p o y t ADJUST RX-6510V AUDIO/VIDEO CONTROL RECEIVER SETTING MASTER VOLUME CONTROL DOWN UP BASS BOOST INPUT ANALOG/DIGITAL SPEAKERS ON/OFF DSP MODE PHONES SURROUND ON/OFF FM/AM ...

power supply. A. Using the Supplied FM Antenna The FM antenna provided can be connected to the FM 75 Ω COA ...

Notes: • If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram. • Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception. • If reception is poor, connect an outdoor ...

The required speaker impedance of the front speakers does differ depending on whether both the FRONT SPEAKERS 1 and FRONT SPEAKERS 2 terminals are used or only one of them is used. Front speaker 1 Front speaker 1 Use front speakers with 8 Ω – 16 Ω impedance. Front speaker 1 Front speaker 2 Use front speakers 16 Ω ...

CDR jacks. When connecting a CD recorder to the TAPE/CDR jacks, change the source name, which will be shown on the display when selected as the source, to “CDR.” See page 12 for details. If your audio components have a COMPU LINK jack See also page 26 for detailed inform ...

To audio output TV DVD player Å To front left/right channel audio output (or to audio mixed output if necessary) ı To S-video output Ç To composite video output DVD player VIDEO VCR OUT (REC) IN (PLAY) MONITOR OUT DVD DVD A B C AUDIO RIGHT LEFT DVD • When you connect the DVD player with stereo output jacks: Digital connecti ...