Kenwood TK-2140 Instruction Manual

09 08 07 06 05 04 03 INSTRUCTION MANUAL VHF FM TRANSCEIVER TK-2140 TK-3140 UHF FM TRANSCEIVER ...

Turn off your transceiver while taking on fuel, or while parked in gasoline service stations. ◆ Government law prohibits the operation of unlicensed radio transmitters within the territories under government control. ◆ Illegal operation is punishable by fine and/or imprisonment ◆ Refer service to qualified technicians only. SAFETY: It is important that the operator is aware of and understan ...

applicable: ATTENTION (U.S.A. Only): The RBRC Recycle seal found on KENWOOD nickel-cadmium (Ni-Cd) battery packs indicates KENWOOD’s voluntary participation in an industry program to collect and recycle Ni-Cd batteries after their operating life has expired. The RBRC program is an alternative to disposing Ni-Cd batteries with your regular refuse or in municipal waste streams, which is illegal in some are ...

SUPPLIED ACCESSORIES ......................................... 1 PREPARATION .................................................. 2 BATTERY PACK PRECAUTIONS .................................... 2 INSTALLING/ REMOVING THE (OPTIONAL) RECHARGEABLE BATTERY PACK OR ALKALINE BATTERY CASE ............................... 7 INSTALLING/ REMOVING ALKALINE BATTERIES ...................... 8 INSTALLING TH ...

TRANSMITTING.................................................20 RECEIVING ....................................................20 SYSTEM SCAN (Trunking Format) ...........................21 SCANNING TRUNKED SYSTEMS ..................................21 SCANNING CONVENTIONAL SYSTEMS .............................21 SCAN LOCKOUT................................................22 SCAN REVERT .............. ...

Note: The following unpacking instructions are for use by your KENWOOD dealer, an authorized KENWOOD service facility, or the factory. Carefully unpack the transceiver. We recommend that you identify the items listed in the following table before discarding the packing material. If any items are missing or have been damaged during shipment, file a claim with the carrier immediately. SUPPLIED ACCESSORIES m etI r e b m u ...

◆ Do not recharge the battery pack if it is already fully charged. Doing so may cause the life of the battery pack to shorten or the battery pack may be damaged. ◆ After recharging the battery pack, disconnect it from the charger. If the charger power is reset (turned ON after being turned OFF), recharging will start again and the battery pack will become overcharged. ◆ Do not use the transceiver while charging the battery ...

If the insulator is melted, the gas release vent or safety function is damaged, or the electrolyte is ignited, the battery may generate heat or smoke, rupture, or burst into flame. • Do not use or leave the battery near fires, stoves, or other heat generators (areas reaching over 80°C/ 176°F)! If the polymer separator is melted due to high temperature, an internal short-circuit may occur in the indi ...

The battery may generate heat or smoke, rupture, or burst into flame. • Do not solder directly onto the battery! If the insulator is melted or the gas release vent or safety function is damaged, the battery may generate heat or smoke, rupture, or burst into flame. • Do not reverse the battery polarity (and terminals)! When charging a reversed battery, an abnormal chemical reaction may occur ...

If the battery pack has not finished charging even after the regulated time has passed, stop it. The battery may generate heat or smoke, rupture, or burst into flame. • Do not place the battery pack into a microwave or high pressure container! The battery may generate heat or smoke, rupture, or burst into flame. • Keep ruptured and leaking battery packs away from fire! If the battery ...

• As the battery pack is charged and discharged repeatedly, the battery capacity decreases. • Even if the battery pack is unused, the battery pack degrades. • It takes a longer time to charge the battery pack in cooler areas. • The life of battery pack is shortened when it is charged and discharged in hotter areas. When the battery pack is stored in a hot location, the battery pack degrades quicker. ...

PACK OR ALKALINE BATTERY CASE 1 Match the guides of the battery pack with the corresponding grooves on the upper rear of the transceiver, then firmly press the battery pack to lock it in place. 2 Flip the safety catch into place to prevent accidentally pressing the release latch and removing the battery. 3 To remove the battery pack, lift the safety catch, press the release latch, then pull the bat ...

◆ Do not install batteries in a hazardous environment where sparks could cause an explosion. ◆ Never discard old batteries in fire; extremely high temperatures can cause batteries to explode. ◆ Do not short circuit the battery case terminals. ◆ Do not use commercially available rechargeable batteries. Note: ◆ If you do not plan to use the transceiver for a long period, remove the batteries from the batter ...

connector on the top of the transceiver by holding the antenna at its base and turning it clockwise until secure. INSTALLING THE (OPTIONAL) ANTENNA INSTALLING THE BELT CLIP Note: When first installing the belt clip, you must remove the battery pack from the rear of the transceiver. 1 Remove the two screws from the rear of the transceiver, then remove the small, plastic black covering that was held in place. 2 Insert the belt c ...

KMC-25 speaker/ microphone, install the cover over the univeral connector using the supplied 4 x 6 mm dressed screw. INSTALLING THE COVER OVER THE UNIVERSAL CONNECTOR INSTALLING THE (OPTIONAL KMC-25) SPEAKER/ MICROPHONE 1 Insert the guide of the speaker/ microphone connector into the groove of the universal connector. 2 Secure the connector in place using the attached screw. ...

Connect an (optional) antenna here. w w w w w Rotary encoder Rotate this encoder to activate its programmable function. (System or Group Up/ Down in Trunking Format, and Group or Channel Up/ Down in Conventional Format.) For further details, contact your dealer. e e e e e POWER switch/ VOLUME control Turn clockwise to switch ON the transceiver. Rotate to adjust the volume. Turn counterclockwise fully to ...

This LED lights red during transmission and green while receiving a signal. During Sel Call Alert, the LED flashes orange. If programmed by your dealer, when the battery pack power is low, the LED flashes red during transmission. Replace or recharge the battery pack at this time. Note: While operating the transceiver using a Li-ion battery pack, the battery low indication time may be much shorter than when using other battery ...

13 DISPLAY r ota cid nI n oitpirc s e D nir e b m u n p u o r g r o le n n a h c e ht s y alp si D p u o r g r o m ets y s e ht d n a ta m r ofla n oitn e v n o c .ta m r of g nik n u rt nir e b m u n .n a c S ytir oir P g ni m r ofr e p n e h w sr a e p p A s a d e m m a r g o r p y e k e ht n e h w sr a e p p A r o ti n o M si .d e s s e r p .r e vie c s n a rt siht n o d e s u to n si n o ci sih T .n a c S g ni m r ofr e p n e h w sr a e p p A s a d e m ...

Keys w, t, o and !0 {pages 11 and 12} can be programmed with the auxiliary functions listed in the following table. The keys can only be programmed with functions, depending on whether you are using Conventional Format or Trunking Format. Please contact your dealer for further details on these functions. n oitc n u F la n oitn e v n o C ta m r o F g nik n u r T ta m r o F e n o h p ele T o t u A o N s e Y n w o D le n ...

15 n oitc n u F la n oitn e v n o C ta m r o F g nik n u r T ta m r o F y r a t n e m o M r o tin o M s e Y s e Y elg g o T r o tin o M s e Y s e Y e n o N s e Y s e Y e n o T elb a tc ele S r o t a r e p O s e Y o N laid e R s e Y s e Y w o L r e w o P F R s e Y s e Y n a c S s e Y s e Y d d A /le D n a c S s e Y s e Y e t ele D y r a r o p m e T n a c S o N s e Y n oit a u n e tt A P S 4 s e Y s e Y le v e L h cle u q S s e Y o N y r a t n e m o M ff O h ...