KitchenAid DVM-1815 Installation Manual

IMPORTANT: READ AND SAVE THESE INSTRUCTIONS. INSTALLATION REQUIRES 2 OR MORE PEOPLE. INSTRUCCIONES DE INSTALACIÓN Refrigeradores empotrados de dos puertas y con montaje inferior IMPORTANTE: LEA Y GUARDE ESTAS INSTRUCCIONES. LA INSTALACIÓN REQUIERE DE 2 O MÁS PERSONAS. INSTRUCTIONS D� ...

REFRIGERATOR SAFETY.......................................................... 3 INSTALLATION REQUIREMENTS................................................4 Tools and Parts ............................................................................4 Product Dimensions.....................................................................4 Lo ...

immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. Your ...

IMPORTANT: I Observe all governing codes and ordinances. I Installer: Leave Installation Instructions with the homeowner. I Homeowner: Keep Installation Instructions for future reference. Save these Installation Instructions for the local electrical inspector’s use. I Keep cardboard shipping piece or plywood unde ...

NOTE: Width dimensions shown represent distance from outside trim to outside trim. Width of Refrigerator: Front View for Bottom Mount Models NOTE: Width dimensions shown represent distance from outside trim to outside trim. Opening Dimensions The built-in refrigerator can be installed into a recessed opening in the cabine ...

either side of the refrigerator. The right-hand side is recommended. The access hole through the right cabinet must be within ¹⁄₂ in. (12.7 mm) of rear wall. 4. A ¹⁄₂ in. (12.7 mm) hole for plumbing should be within the bottom shaded area (see the “Connect Water Line to Refrigerator ...

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. IMPORTANT: If this product is connected to a GFCI (Ground Fault Circu ...

Bottom Mount Models Door Swing Dimensions Location must permit doors to open to a minimum of 90°. For panel models, allow 1 in. (2.5 cm) minimum space between refrigerator side and corner wall. For wraparound models, allow 4¹⁄₂ in. (11.4 cm) minimum space between refrigerator side and corner wall. To adjust door swing see the � ...

All factory parts are available through your KitchenAid dealer or by calling KitchenAid Parts and Accessories at 1-800-442-9991. Factory Door Panels Kits Four kits containing colored acrylic or stainless steel door and top grille panels are available. Follow the kit instructions for installing the panels. NOTE: ...

The two freezer panels combined should not weigh more than 30 lbs. (13.5 kg). The refrigerator panel should not weigh more than 50 lbs. (23 kg). Bottom Mount Custom Top Grille and Door Panels Top Grille Panel The top panel should not weigh more than 10 lbs. (4.5 kg). Refrigerator and Freezer Door Panels The freezer panel s ...