Kompernass KH 4056 Operating Instructions

ID-Nr.: KH4056_09/06_V1 www.kompernass.com UK KH4056_IB_UK 19.09.2006 14:23 Uhr Seite 1

KH 4056 � Bicycle Hoist KH 4056 Safety information • Read the operating instructions care- fully before using the appliance for the first time and preserve this book- let for later reference. Pass the manual on to whomsoever might acquire the appliance at a later date. • Never lift more than 20 kg with the bicycle hoist. This would damage the bicycle hoist and cause the load to crash down. • Check for the correct tightness of all screws before using the bicycle hoist. • At all times use the wall bracket for securing the load. Otherwise, the load could crash down. • Do not take up a position underneath the hanging load. • Use the bicycle hoist for storage only, not for any other purpose. • Do not carry out repairs on the sus- pended load. • Should the nylon cord be damaged, exchange it as soon as possible. It could tear. � Attention Ensure that the nylon cord does not slide too fast between your hands! It could lead to burns and ab- rasions! � Attention The bicycle hoist may not be operated by weak people, for example children. The bicycle could crash down and cause injuries. Intended use The bicycle hoist is intended to save space and relieve the tyres during bicycle storage. It is not meant to be used for commer- cial purposes. Delivery Contents 2 Ceiling brackets 2 Double retaining hooks 1 Nylon cord 1 Wall bracket for the nylon cord 10Cross-head screws with plugs Description of the appliance � Ceiling bracket � Nylon cord � Safety mechanism � Double retaining hooks � Cross-head screws � Plugs � Wall bracket Required assembly tools: 1 Cross-head screwdriver 1 Measuring tape 1 Drill 1 Drill bit (8 mm diameter) KH4056_IB_UK 19.09.2006 14:23 Uhr Seite 3

KH 4056 � Assembly The best assembly results are achieved when the ceiling brackets are located directly above the seat and handlebars. Ensure there is sufficient clearance from the side walls. 1. Measure the distance between the handlebars and the seat on your bicycle. 2. Transfer this measurement to the cei- ling, marking the required drill-holes with the aid of a ceiling bracket. Drill the required holes and insert the plugs. 3. Make a stable square knot at one end of the nylon cord and thread it through the rear ceiling bracket (See Fig. 1). 4. Fasten both ceiling brackets to the ceiling with the supplied cross-head screws and plugs (see Fig. 1). 5. Connect the construction with the cord in accordance with the block and tackle principle. Run the cord through the rollers in alternation, starting at the ceiling bracket (see Fig. 3). 6. Run the cord through the safety mechanism in the ceiling bracket. (see Fig. 2). 7. Check that all screws are firmly tighte- ned before using the bicycle hoist. 8. Assemble the wall mount. To do this, lift the bicycle with the hoist and mark the position for the wall mount. 9. After assembling the wall mount, check all screw connections for tight- ness again. � Notice: Should the cord slip quickly through your hands when raising or lowering the bicycle, the increased tempo of the cord itself will trigger the brake and the cord will stop auto- matically. Maintenance Grease the rollers at regular intervals. This will ensure that the bicycle hoist moves easily. Disposal The packaging consists of 100% environ- mentally friendly materials that can be disposed of at local recycling collection sites. Contact your municipal or commu- nity administration for information on disposal possibilities for metallic compo- nents. Importer Kompernaß GmbH Burgstrasse 21 D-44867 Bochum www.kompernass.com KH4056_IB_UK 19.09.2006 14:23 Uhr Seite 4