Kramer VS-1616V Operation & User’s Manual

3 5 Your Video Matrix Switcher 4 6 Installing the Video Matrix Switcher 7 6.1 Configuring a Stand Alone Switcher 7 6.1.1 Configuring a single VS-1616V Unit (16x16 CV) for Composite Video 8 6.1.2 Configuring a single VS-1616V Unit (8x8 Y/C Switch ...

ii 7.2.2.1 Switching one Input to one Output 29 7.2.2.2 Switching several Inputs to several Outputs 30 7.2.2.3 Switching one Input to all Outputs 31 7.2.3 Clearing 32 7.2.3.1 Clearing an Output 32 7.2.3.2 Clearing several Outputs 33 7.2.3.3 Clearing all Outputs 34 7.2.4 Storing and Recalling Setups 35 7.2.4.1 Storing Setups ...

3 Figure 2: VS-1616V 16x16 Video Matrix Switcher 5 Figure 3: Configuring the VS-1616V for Composite Video (CV) 8 Figure 4: Configuring the VS-1616V for s-Video (Y/C) 8 Figure 5: Configuring the VS-1616V for YUV (RGB) 9 Figure 6: Configuring the VS-1616V for RGBS 9 Figure 7: Configuring a 16x1 ...

ADDENDUM: VS-1616A, VS-1616AD, VS-1616SDI, VS-1616V, and VS-162V This addendum describes the ASCII protocol in the 1616 series. The ASCII protocol applies to firmware version 3.3 or higher. ASCII Protocol: General The ASCII protocol has 3 basic commands: Y for connect, T for recall, P ...

manufacture of high quality video/audio equipment, makes the Kramer line an integral part of the finest production and presentation facilities in the world. In recent years, Kramer has redesigned and upgraded most of the line, making the best even better! The Kr ...

2 3 Overview The Kramer VS-1616V is a high performance 16x16 vertical interval matrix switcher for composite video signals on BNC connectors. In addition to its typical 16x16 operation, the VS-1616V can be configured as follows: �� 8x8 for s-Video (Y/C) �� 5x5 for YUV or RGB (with the sync on the Green signal - RGsB) ...

3 Control the VS-1616V: �� Using the front panel buttons �� Remotely, by RS-485 or RS-232 serial commands transmitted by a touch screen system, PC, or other serial controller �� Remotely, from the Kramer IR-1 Infra-Red Remote Control Transmitter �� Via external dry-contact push buttons To achieve the ...

KRAMER ELECTRONICS, LTD. 4 Table 1: Quick Reference Operating Guide for a Single Machine To perform this command: Press: Connect an input with an output OUT #; IN # Reset a specific output OUT #; OFF Reset all outputs ALL; OFF Connect all outputs to a specific input ALL; IN # Store a setup STO; OUT #; TAKE Recall a setup RCL; OUT # ...