Lexmark E260d Quick Reference

specialty media This section explains how to load the 250- and 550-sheet trays, and the manual feeder. It also includes information about setting the Paper Size and Paper Type. Setting the paper size and paper type Make sure the settings for the trays reflect the size and type of paper loaded in the trays. The factory defaul ...

extends backwards. If you are loading A6-size paper: a Squeeze the length guide tabs together as shown, and slide the length guide toward the center of the tray to the A6 size position. b Raise the A6 length guide. Note: The standard tray accommodates only 150 sheets of A6-size paper. 4 Flex the ...

8 If a different type of paper was loaded than the type previously loaded in the tray, change the Paper Type setting. Note: The difference between the standard 250-sheet tray and the optional 250- and 550-sheet trays is that the standard tray accommodates up to 150 sheets of A6-size paper, so the width guides slide farther to the center of ...

Notes: • Do not leave the paper stop in the open position if you are printing on transparencies. Doing so may cause creases in the transparencies. • When moving the printer to another location, make sure the paper stop is closed. Paper capacities The capacities of the trays and the manual feeder are ba ...

• Use only recommended paper or specialty media. • Do not load too much paper. Make sure the stack height does not exceed the indicated maximum height. • Do not load wrinkled, creased, damp, or curled paper. • Flex, fan, and straighten paper before loading it. • Do not use pap ...

- On - On - On Open the front door, and then open the rear door. 231.yy Paper jam - On - Blinking - On Open the front door, and then open the rear door. 233.yy Paper jam - On - Blinking - Blinking - On Try one of the following: • Remove Tray 1, and then depress the lever. • Open the front door, and then open the rear door. 234. ...

• Remove Tray 1. • Open the front door, and then remove the photoconductor kit and toner cartridge unit. • Remove Tray 2. 251.yy Paper jam - On - On - On - On Remove the jam from the manual feeder. Clearing jams behind the photoconductor kit and toner cartridge 1 Push the release button, and then lower the front door. 2 Li ...

standard exit bin. Clearing jams from Tray 1 To see whether paper is jammed in or behind Tray 1, the standard tray: 1 Remove Tray 1. 2 Remove the jammed paper. 3 If necessary, depress the lever to free the paper and remove the jam. 4 Insert the tray. 5 Press to continue printing. Clearing jams in ...

pulled straight out. If the jam cannot be removed this way, check for jammed paper behind the photoconductor kit and toner cartridge unit. For more information, see “Clearing jams behind the photoconductor kit and toner cartridge” on page 7. Clearing jams behind the rear door If the paper is ex ...