Liebherr HC1001 Installation Instructions Manual

Text of the manual

Combined fridge-freezer, fully

integrated Instructions de montage Combiné réfrigérateur- congélateur, entièrement intégrable Instrucciones de montaje Combinado frigorífico-congelador, integrable en mueble alto HC1011/1060 HC1001/1050 111113 7084000 - 03

General safety information...........................

2 2 Setting up the appliance............................... 2 3 Kitchen Cabinet Construction...................... 3 3.1 Kitchen Cabinet Airflow.................................... 3 3.2 Designing the Kitchen Cabinet......................... 5 3.3 Designing the Kitchen Cabinet Doors............

Risk of damage for the finished floor surface!

u Protect the finished floor surface before you uncrate the unit. Verify that: q The floor under the appliance is flat and level. q The floor can support the appliance's weight plus approximately 1200 pounds (544 kg) of food weight. q The appliance is not placed in direct sunlight or near the stove, range

- There must be a clear ventilation space (without any

obstructions) of at least 1-1/2 in. (38 mm) at the back of the kitchen cabinet. u Observe the above ventilation dimensions. Ventilation through the cabinet base at the bottom can be achieved by installing the provided ventilation grille Fig. 3 (3) or via a ventilation opening of at least 31 in2 (2

3.2 Designing the Kitchen Cabinet

Fig. 4 1 Power cord 3 Electrical outlet 2 Level 4 Fish line for power cord A 21-7/32 in. (539 mm) B 69-21/32 in. (1769.5 mm) C 21-15/16 in. (557 mm) D 69-3/4 in. - 70-3/8 in. (1772 mm) - (1788 mm) E min. 22 in. (560 mm) F 21-21/32 in. (550 mm) max. 22-3/4 in. (578 mm) G 1-1/2 in. (38 mm) H 27-3/8 in. (695 mm) J 24-3/4 in. (6

3.3 Designing the Kitchen Cabinet

Doors Fig. 5 You need two doors for the kitchen cabinet, one on top for the refrigerator compartment, and one on the bottom for the freezer compartment. In general, the doors have these characteristics: - The doors should be at least 5/8 in. (16 mm) and max. 3/4 in. (19 mm) thick to allow the connecting rails to be fastened

Unit door fridge compartement

3 Fridge compartement door 2 Unit door freezer comparte- ment 4 Freezer compartement door The freezer door height is 24-24/32 in. (629 mm). u To cover the lower part of the appliance: increase the height of the panel to 27-3/32 in. (695 mm). The thickness of the floor board is usually 3/4 in. (19 mm). u To cover the fac

u The total opening of the cabinet (i.e. 70-3/8 in.

(1788 mm)) plus the thickness of the top as well as the floor board (usually 3/4 in. (19 mm)) minus the height of the freezer door panel (xxx in. (xxx mm)) as calculated above and subtract the width of the gap (approximately 1/8 in. (3 mm)): 70-3/8 in. + 3/4 in. + 3/4 in. - xxx in. - 1/8 in. = 71-25/32 in.

Other Refrigerator Manuals