Lightolier CACS series Installation

Text of Lightolier CACS series Installation

INSTALLATION OF STEM KIT ONTO CEILING

(Fig. 1 & 2) (NOTE: If custom length is required see page 2.) 1. Assemble STEM to BALL ALIGNER using set screws. Pull wires through BALL ALIGNER leaving no less than 6" exposed. 2. For sloped ceilings, position opening in CROSSBAR facing upward. (Fig. 2) Install CROSSBAR using OUTLET BOX SCREWS. 3. Place BALL ALIGNER of STEM into CROSSBAR through side access hole. When seated the BALL ALLIGNER keyway will lin

PAD ( DISCARDED)

INSTALLATION OF CEILING MOUNT CYLINDER TO STEM (Fig. 1 & 3) 1. Attach (2) SPRING CLIPS to CYLINDER HOUSING by sliding SPRING CLIPS onto (2) raised pockets on top of CYLINDER HOUSING. NOTE: Discard SPRING CLIPS for Cylinders which do not have the raised pockets; these cylinders have integral tap holes. (Fig. 3) 2. For C7CS series cylinders, tear off the fiberglass pad from top of cylinder. The remaining fibe

Lightolier Indoor Furnishing Owners Instructions: