Martin ATOMIC 3000 Operation & User’s Manual

All rights reserved. No part of this manual may be reproduced, in any form or by any means, without permission in writing from Martin Professional A/S, Denmark. P/N 35000094, Rev D 5 x Ø12.20 143 496 90 150 84 450 239 424 234 ...

3 Contents Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Preparation for use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9 Controller operation . . . . . . . . . . . . ...

SAFETY INFORMATION 1 Warning: This product is for professional use only! It is not for household use. The Atomic 3000 presents risks of lethal or severe injury due to fire and heat, electric shock, ultraviolet radiation, and falls. Flashing light is also known to trigger epileptic seizures in persons who are photo ...

Safety information 5 • Keep all combustible materials (for example fabric, wood, paper) at least 0.5 meters (20 inches) away from the fixture. Keep flammable materials well away from the fixture. • Do not illuminate surfaces within 1 meter (39 inches) of the fixture. • Provide a minimum clearance of 0.1 meters (4 inches) around ...

Atomic 3000 user manual PREPARATION FOR USE 2 U N P A C K I N G The Atomic 3000 comes with the following items: • Martin MAX-15 or MAX-7 xenon lamp (installed) • Mounting bracket • User manual The packing material protects the fixture during shipment; always use it to transport the fixture. AC P O W E R C O N N E C T I O N The ...

Preparation for use 7 • Following the cord cap manufacturer’s instructions, connect the yellow and green wire to ground (earth), the brown wire to live, and the blue wire to neutral. The table below shows some pin identification schemes. I N S T A L L A T I O N The Atomic 3000 may be installed in any orientation. The mounting bra ...

Atomic 3000 user manual To rig the fixture Warning: Always use a secure means of secondary attachment! Before installing, verify that • the attachment hardware is in good condition and designed to bear at least 10 times the fixture’s weight, • the structure can support at least 10 times the weight of all installed fixtures, clamps ...

Lamp 9 LAMP 3 This section describes the lamp options, the lamp power setting, and how to replace the lamp. The lamp is electronically regulated to prevent overheating. Lamp regulation can be seen, for example, by the gradually decreasing intensity of the blinder effect. L A M P P O W E R S E T T I N G The Atomic 3000 provides high a ...

Warning: Installing any other lamp may create a safety hazard or damage the fixture! Important: Use only replacement lamps from Martin! User only replacement lamps from Martin that have been prepared for use with an ionization wire. XOP lamps without an ionization wire will not work. L A M P R E P L A C E M E N T End of life ...