MaxTech XT-7871 Operation & User’s Manual
Text of MaxTech XT-7871 Operation & User’s Manual
Part #MAN124 Rev. 1.0
XT7871
XT-7871
USER'S MANUAL
• 0.28 mm Dot Pitch
• 1280 x 1024, Non-Interlaced
• 120 Hz Refresh Rate
• Power Saving Operation (VESA DPMS)
• Anti-Static, Anti-Glare Screen
• Full Screen Display
• Digital Controls with OSD
• Low Radiation (MPR-II)
• Plug and Play
• Three-Year Warranty
Features
Table of Contents
Section 1
General Information ................................................... 2
Section 2
Installation .................................................................. 2
Section 3
Monitor Controls and LEDs ........................................ 3
Section 4
Troubleshooting ......................................................... 6
Section 1 - General Information
Congratulations on purchasing a MaxTech 17-inch high resolution color monitor.
The monitor uses one of the finest CRTs available in the industry. The 0.28 mm
dot pitch non-glare tube provides a crisp and vivid color display. The monitor
complies with the MPR-II standard to reduce electro-magnetic emissions. Ad-
vanced electr
Section 3 - Monitor Controls and LEDs
3.1 Controls and LEDs
Expansion boards
COM1
COM2
LPT1
VIDEO
Figure 2-1 Monitor Connections
Figure 3-1 Master Power Control
1
Master Power (On rear): Push to provide power to the monitor. This switch
should be left ON for daily operation. Use the front panel On/Off control (3) to
turn the monitor display on and off.
2.
Power Saving Indicator: When lit, the monitor is in the DPMS OFF mode.
3.
ON/OFF: Press this switch to turn the monitor display on, press again to turn
the moni
The On-Screen Display (OSD) is enabled by pressing either button of control
pair 6 (see Figure 3-2). Control pair 5 (+ and -) buttons are used to increase or
decrease the value of selected parameter.
A.
Horizontal-Size: Adjusts the display width. The (+) button increases the
width. The (-) button decreases the width.
B.
Horizontal-Pos
Section 4 - Troubleshooting
No picture, no LEDs lit.
• Check that the AC cord is plugged into an outlet and the monitor.
• Turn on the Master Power switch.
No picture, power LED is lit.
• Monitor is in DPMS STANDBY/SUSPEND mode. Press a key or move the
mouse.
• Check that video cable is connected completely.
• Adjust brightness and contrast contr
Appendix A - Specifications
Picture Tube
Size
17-inch diagonal
Dot pitch
0.28mm
Horizontal Freq
30-66KHz
Vertical Freq.
50-120 Hz
Resolution (Max.)
1280 x 1024
Video Dot Rate
100 MHz
Data Area
11.8 in. x 8.7 in.
Maximum Refresh Rates
Resolution
Refresh (Vertical) Frequency
640 x 480
120Hz
800 x 600
100 Hz
1024 x 768
80 Hz
1280 x 1024
60 Hz
Input voltage
11
Appendix B - Video Cable Pinout
Appendix C - Power Saving Modes (DPMS)
VESA Display Power Management Signaling (DPMS) defines a method for a
computer to signal the monitor to reduce its power consumption when idle. DPMS
features must be supported by both the computer and the monitor. This monitor
supports DPMS “SUSPEND” “STANDBY” and “OFF” mode
Appendix D - Three Year Warranty
MAXTECH warrants to the original buyer of this product against defects in
material and workmanship for three years from the date of purchase.
Except as specified below, this warranty covers all defects in material or
workmanship in this product. The following are not covered by the warranty:
1. Any product which is not dist