Metra Electronics 95-5810 Installation Instructions Manual
Text of the manual
INSTALLATION INSTRUCTIONS FOR PART 95-5810
95-5810
KIT FEATURES
• Double DIN Radio Provision
• Stacked ISO Mount Units Provision
A) Double DIN Trim Plate B) Double DIN Brackets
KIT COMPONENTS
A
Small Flat Blade Screwdriver/ Panel Removal Tool
• Socket Set
1-800-221-0932
© COPYRIGHT 2007-2009 METRA ELECTRONICS CORPORATION
www.metraonline.com
TOOLS
- LINCOLN Town Car 2003-2011 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Kit Assembly
- Double DIN Radio Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
- Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Final Assembl
95-5810 DASH DISASSEMBLY
LINCOLN TOWN CAR 2003-2011
1
10
0
20
30
40
50 60 70
80
90
100
100
60
20
140
180110
120
P
C
H
R N
2 1
MPH
0.0
MILES
LINCOLN
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Remove (2) 7mm bolts facing upward
above instrument cluster/gauges.
(Figure A)
2
Carefully unsnap and remove dash
panel surroun
95-5810 KIT ASSEMBLY
B
A
DOUBLE DIN RADIO PROVISION
Attach the Double DIN brackets to the
aftermarket radio using the screws
supplied with the radio. (Figure A)
1
Place the Double DIN trim plate over
the radio face then secure the entire
assembly into the sub dash. (Figure B)
2
Continue to final assembly.
*Note: Refer also to the instructions included wit
95-5810 KIT ASSEMBLY
B
A
STACKED ISO MOUNT UNITS PROVISION
Attach the Double DIN brackets to the
aftermarket units using the screws
supplied with the units. (Figure A)
1
Place the Double DIN trim plate over
the unit faces then secure the entire
assembly into the sub dash. (Figure B)
2
Continue to final assembly.
*Note: Refer also to the instructions inclu
95-5810 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect
REV. 11/18/10 © COPYRIGHT 2007-2009 METRA ELECTRONICS CORPORATION INST95-5810
www.metraonline.com