Milwaukee 6391 Operator's Manual

AFIN DE RÉDUIRE LE RISQUE DE BLESSURES, L’UTILISATEUR DOIT LIRE LE MANUEL DE L’UTILISATEUR. PARA REDUCIR EL RIESGO DE LESIONES, EL USUARIO DEBE LEER EL MANUAL DEL OPERADOR. Cat. No. No de cat. 6391 OPERATOR’S MANUAL MANUEL de L’UTILISATEUR MANUAL del OPERADOR HEAVY DUTY LEFT BLADE CIR ...

ELECTRICAL SAFETY PERSONAL SAFETY WARNING READ ALL INSTRUCTIONS Failure to follow all instructions listed below may result in electric shock, fi re and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. SAVE THESE I ...

and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below: a. Maintain a fi rm grip with both hands on the saw and position your arms to resist kickback forces. Position your body to either side of the blade, but not in line with the blade. Kickback could caus ...

sion cord. Double insulated tools can use either a two or three wire extension cord. As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool dam ...

unplug tool before attaching or removing accessories or making adjustments. Use only specifi cally recommended accessories. Others may be hazardous. Selecting Blade Always use sharp blades. Dull blades tend to overload the tool and increase the chance of kickback (see “Preventing Kickback”). ...

Fig. 11 4. To adjust the handle position, hold the front handle and rotate the Tilt-Lok™ handle to the desired angle as indicated by the handle rotation adjustment mark- ings (Fig. 10). The Tilt-Lok™ feature has eight (8) detents which allow the handle to snap into position. Allow the detent to snap int ...

saw horse or bench (Fig. 13). See “APPLICA- TIONS” for the correct way to support your work in different situations. 1. Draw a cutting line. Place the front of the shoe on the edge of the workpiece without making blade contact. Hold the Tilt-Lok™ handle with one hand and t ...

workpiece when it can not be cut from an edge. We recommend using a Sawzall® reciprocating saw or jig saw for this type of cut. However, if you must use a circular saw to make a pocket cut, USE EXTREME CAUTION. To maintain control of the saw during pocket cutting, keep both hands on the saw (Fig ...

regular maintenance program. Before use, examine the general condition of your tool. Inspect guards, switches, tool cord set and extension cord for damage. Check for loose screws, misalignment, binding of moving parts, improper mounting, broken parts and any other condition that may affect i ...

DE TRAVAIL AVERTISSEMENT LIRE SOIGNEUSEMENT TOUTES LES INSTRUCTIONS Le non respect des instructions ci-après peut entraîner des chocs électriques, des incendies et/ou des blessures graves. Le terme «outil électrique» fi gurant dans les avertissements ci-dessous renvoie à l’outil électrique à alimentation par le réseau (� ...