MINN KOTA Riptide RT Owner's Manual
Text of MINN KOTA Riptide RT Owner's Manual
SERIAL NUMBER MK
PURCHASE DATE
Feature Information
Installation
Operation
Maximizer
Battery
Wiring Diagram
Propeller Replacement
Maintenance
Troubleshooting
Limited Warranty
Transom Mount
Hand Control
Saltwater
Trolling Motors
OWNER’S MANUAL
NOTE: DO NOT RETURN YOUR MINN KOTA MOTOR TO YOUR
RETAILER.YOUR RETAILER IS NOT AUTHORIZED TO REPAIR
OR REPLACE THIS UNIT.YOU MAY OBTAIN SERVICE BY:
• CAL
Tilt Twist Tiller
Handle
2
Specifications subject to change without notice.
Steering Tension Knob
High Strength
Multi-Position Bracket
Replaceable
Sacrificial Anode
Extends Protection
Against Galvanic
Corrosion
Advanced Saltwater Corrosion
Protection:
3-mil acrylic paint
E-coated epoxy
Chromate conversion coat
7-step cleaning process
Premium marine alloy
Flexible
Lifetime Warranty
Composite Shaft
Maximizer / Perm
MOUNT THE MOTOR:
Install the motor on the transom of the boat.
Be sure to [ hand only ] tighten the clamp
screws securely.
DEPTH ADJUSTMENT:
• Firmly grasp the composite shaft and
hold it steady. Be careful, the RT101 is
heavy.
• Loosen the steering tension knob and
depth collar knob until the shaft slides
freely.
• Raise or lower the motor to the desired
depth.
• Tighten depth collar knob to secure the
motor in place.
NOTE: When set
You can lock your motor in a vertical posi-
tion, angle it for shallow water or tilt it com-
pletely out of the water.
• Firmly grasp the control head or compos-
ite shaft.
• Depress and hold the tilt release button.
• Tilt to any of the positions on the mount-
ing bracket.
• Release the tilt button.
OPERATION
4
Release Button
Handle Controls ON/OFF,
Steering, Forward/Reverse.
TWIST TILLER
These Riptide motors [except
RT40/42/50
Riptide 12V motors will operate with a deep
cycle marine 12 volt battery; 24V motors
require two 12V batteries wired in series;
36 volt motors require three 12V batteries
wired in series. For best results, use deep
cycle Minn Kota marine batteries with at
least a 105 ampere hour rating. As a gen-
eral on the water estimate, your 12 volt
motor will draw 1.0 ampere/hour, your 24
volt motor will draw .75 ampere/hour, 3
• BEFORE CONNECTING BATTERY, MAKE SURE THE
TWIST TILLER HANDLE IS IN THE OFF POSITION.
• USE 6 GAUGE WIRE TO EXTEND POWER LEAD.
• KEEP LEADWIRE CONNECTION TIGHT AND SOLID TO
BATTERY TERMINALS.
• LOCATE BATTERIES IN A VENTILATED COMPARTMENT.
• WORKING WITH OR NEAR LEAD ACID BATTERIES IS
DANGEROUS. BATTERIES CONTAIN SULFURIC ACID
AND PRODUCE EXPLOSIVE GASES. I
All Star Specialists
3434A Dilido
Dallas 75228-5652
214-320-1673
or 800-362-3790
Alpha-Omega Electronics
2821 National Drive
Garland 75041
972-271-5569
Anglers Marine Service Center
5000 Sunrise Suite 2D
Round Rock 78664
512-246-0550
Ark-La-Tex Marine, Inc.
916 N Robison Rd
Texarkana 75501-6308
903-838-9518
Atex Generator Shop
509 Brook Ave.
Wichita Falls 76301-2104
940-761-4969
B & W Trolling Motor Service
131 East River Oaks Rd.
Early 76802-26
1819 Holli Park
Idaho Falls 83401
208-525-2028
Mike’s Service Center
1311 E. Linden Ave.
Coeur d’ Alene 83814
208-664-2753
ILLINOIS
Al’s Sporting Goods
514 South Henderson St.
Galesburg 61401-4342
309-342-7776
Croegaert’s Great Outdoors
4002 11th St.
Rock Island 61201
309-788-4868
Even-Keel Marine Inc.
6621 West State St.
Rockford 61102-1252
815-963-1105
Gilmore’s Bait & Marine
15321 Carlinville Lake Rd.
Carlinville 6
40 LBS. THRUST
12 VOLT
36" SHAFT