Moog QRHW SERIES Installation And Operation Instructions Manual

Installation and Operation Instructions for the following models: QRHWT2-70NA Sever and volatile environmental housing, tinted dome with two (2) Day/Night cameras, 3-9mm auto-iris lens QRHWT4-70NA Sever and volatile environmental housing, tinted dome with four (4) Day/Night cameras, 3-9mm auto-iris lens ...

2 Keep these instructions. 3 Heed all warnings 4 Follow all instructions. 5 Do not use this apparatus near water. 6 Clean only with damp cloth. 7 Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions. 8 Cable Runs ...

Moog Videolarm warrants these products to be free from defects in material or workmanship as follows: PRODUCT CATEGORY PARTS \ LABOR All Enclosures and Electronics* Five (5) Years Poles/PolEvators™/CamEvator Three (3) Years Warrior Series™/Q-View™/IR Illuminators Five (5) Years SView Series™ F ...

Power 24VAC, Class 2 Only 26 watts at 24 VAC Heater and Blower Heater: 25 watts Blower: 1 watt Input Connectors (outdoor units): Camera Power, BNC (2) screw-down connectors NOTE: This unit is designed for operation in an upright position. Installing the QRH upside down may cause ...

1. This unit includes a 1 1/2" NPT housing for a standard 1 1/2" NPT pipe. The RH7C can be used with other brackets designed with 1 1/2" male pipe threads, such as the Moog Videolarm WM20G and WM20 wall mount brackets. 2. Attach the housing coupling (Figure 3). NOTE: Pipe threads should be clean and ru ...

power supply for cameras connected in parallel (positive to positive, negative to negative): Total current for a 24 VAC system: TOTAL CURRENT = (202mA x total number of cameras) Example: 202mA x 5 total cameras = 1010mA Note: 202mA is camera plus power supply CAMERAS VOLTAGE CURRENT POWER 1 24 VAC/VDC 102 ...

the dome. DO NOT TAKE THESE SCREWS OUT. Once the screws are loosened, turn the dome counter clockwise until it stops, then pull the dome off. CAMERA FOCUSING (FOR EACH CAMERA) Fixed Lens: Loosen the set screw in the lens mount. Manually rotate the lens unt ...

comparable to a 1/3" chip using a 4-9mm auto iris lens. The operational settings are defined by four dip switches located on the side of the PC Board (Figure 12 and 13). Moving the switches to the UP position will activate specific settings. Refer to the chart below. Figure 12 ...

1. DO use point-to-point Unshielded Twisted Pair wire, gauge 24 or thicker, stranded or solid, Category 2, 3, 4, or 5. 2. The video signal may co-exist in the same wire bundle as other video, telephone, data, control signals, or low-voltage power. It is also OK to run NVT video signals in or near electromagnetic field ...

segment separately. For example, test the camera and monitor together without the other equipment. Then add in the NVT transceivers, back-to-back. Test each segment of a long cable-run independently. Att ...