Moultrie MFHP81565 Instructions

Specifications

Brand: Moultrie
Category: Welding System
Model: MFHP81565
File Type: PDF
File Size: —
Pages: 2

Read Online

Read the Moultrie MFHP81565 Instructions online using the built-in PDF viewer.

Text of the manual

Turn Drum upside down.

Drum Bolts Funnel Short Bolts Place Funnel inside Drum with small end of funnel facing down, and attach with two Short Bolts using nuts and washers provided. Place Feeder on Drum. Attach Feeder Legs to Drum as shown with Long Bolts using nuts and washers provided. Drum Feeder Legs Feeder Feeder Leg Holes Turn drum over, measure and mark the center of the bottom. Center the template on the bottom of the drum and secure with tape. Drill two 3/16" Funnel holes and three 5/16" Feeder Leg holes. Using a Hole Saw, drill a 2-1/4" hole in the center of the bottom of your drum. caution: wear eye protection Long Bolts THANK YOU for your purchase of the Econo Plus Feeder Kit. Please read this sheet before operating the unit. If you should have any questions about this product or any other Moultrie product, please contact us using the information below. To help us to better serve you, please complete and mail the enclosed Warranty Card. DRILLING YOUR DRUM/BARREL/BUCKET MOUNTING THE FEEDER NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna • Increase the separation between the equipment and the receiver Econo Plus Feeder will mount to the bottom of any drum or bucket Funnel Holes Instructions for Econo Plus Feeder Kit

Remove bottom and install a 6-Volt Alkaline (ex.

EnergizerTM) or Moultrie rechargeable battery by attaching the Red Alligator Clip to the positive terminal (+) and the Black Alligator Clip to the negative (-) terminal. Place bottom on unit and secure using wing nut. Unit is now ready for operation. caution: wear eye protection 120704R05 / MFK-EPK .................MFHP81565 .....................................MFHP81693 Your Econo II feeds two times per day, once shortly after daybreak and again in the evening. The evening feed time is modifiable as shown in chart on right. FEEDER WILL SPIN 5 SECONDS AFTER BATTERY IS FIRST CONNECTED AND WILL SPIN AGAIN WHEN THE LIGHT LEVEL CHANGES. Feeder will then be disabled for 7 hours to prevent accidental feedings due to cloud cover or lightning. You can regulate the amount of feed dispensed by setting the switches to the desired Run Time as shown in chart on right. Amount of feed is approximate and will vary. Feed approximately 30 minutes before dark. Feed just before dark 6