MTD 020 Series Operator's Manual

Model Series 020 IMPORTANT: Read safety rules and instructions carefully before operating equipment. Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest- covered, brush-covered, or grass-covered land unless the engine's exhaust system is equipped with ...

11 3 Troubleshooting 13 5 Parts List 14 6 Warranty Back Cover 9 FINDINGMODELNUMBER This Operator's Manual is an important part of your new lawn mower. It will help you assemble, prepare, and maint ...

endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal i ...

result in severe injury, Operation on slopes requires extra caution, If you feel uneasy on a slope, do not mow it, For your safety, use the slope gauge included as part of this manual to measure slopes before operating this unit on a sloped or hilly area, If the slope is gr ...

TO DETERMINE SLOPES WHERE YOU MAY NOT OPERATE SAFELY. _|iiii| Sight and h0id this levelwith a verticaltree... | 15° ,_ WARNING Do not mow on inclines with a slope in excess of 15 deg ...

to your unit only. UnpackingLooseParts Once the carton has been opened, you will find several loose parts like the wheels, handles, and chute deflector. A hardware pack is also included in the carton. Make sure to remove all loose parts before dis ...

the following sizes: 7/16-inch, 1/2-inch, 9/16-inch, 5/8- inch, and 3/4-inch NOTE: Reference to right, left, front, or back of the lawn mower is from the operating position only, unless otherwise stated, SparkPlugWire 1. Disconnect spark plug wire from the spark plug and ground it against t ...

the cable under the lower handle. Attaching"Z" Fitting 2. To make it easier to attach the Z fitting, remove the left side of the blade control handle as shown in Figure 6. 3. Hook the "Z" end of the brake cable into the handle from the outside to the inside, Figure 6. BladeControl Handle ...

corresponding holes on the deck. 2. Using group 5 from hardware pack, place carriage bolts from underside of the deck and up through the chute deflector. See Figure 10. 3. Secure each bolt with a washer and lock nut. FlangeLockNut_ Fiat CarriageBolt Figure 10: Attaching the chute defl ...

IMPORTANT:Your lawn mower was shipped without any oil in the engine or gasoline in the gas tank. Follow the accompanying engine manual to fill up both the oil and gasoline before starting for the first time. For subsequent operation of the lawn mower, it is very important that you check the level of oil and gasoline before operation. • Che ...