Toa TT-104 Operating Instructions Manual
Text of the manual
WARNING : (For U.S.A. only)
This equipment generates, uses, and can radiate radio frequency energy and if
not installed and used in accordance with the operating instructions, may cause
interference to radio communications. It has been tested and found to comply
with the limits for a Class A computing device pursuant to Subpart J of Part 15
of
FRONT PANEL FACILITIES
REAR PANEL FACILITIES
RACK MOUNTING
OPERATION
1. Setting the current time
2. Hour correction
3. Program registration
4. Program check, correction and cancellation
5. Entire program cancellation
6. Program operation
7. Pause mode
8. Using front-mounted AUTO/OFF switch
9. Using manual switch
10.
FRONT PANEL FACILITIES
ADJUST key-Press the TIME key or DAY key with
ADJUST key continuously pressed to set a clock
for the current time.
00 SEC. key-Use this key to adjust a clock to
seconds. As soon as the key is pressed with the
ADJUST key pressed continuously, the clock is
reset to zero second and a new counting of
second gets started. Pressing the key w
FRONT PANEL FACILITIES
CHANNEL key-Use this key to select the
program output. Pressing the key causes
the corresponding channel indicator on
the right side of each key to come on.
DAY key-This key is used to register a
weekly program. Press the key, and
the DAY indicators flash, allowing a
day of the week to be set with the day
setting under each indicator.
REAR PANEL FACILITIES
CHANNEL ASSIGNMENT switch-Set each
switch to ON when assigning all of B, C and D
channels to the A channel. When, for example,
the B channel switch is set to ON, the A channel
relay contact connects at the time programed for
both A and B channel. In this event, the B
control output does not work.
OUTPUT CHANNEL terminal
Output capacity
