N-Tron 105M12 Installation Manual

820 S. University Blvd., Suite 4E Mobile, AL 36609 USA All rights reserved. Reproduction, adaptation, or translation without prior written permission from N-TRON Corp. is prohibited, except as allowed under copyright laws. Ethernet is a registered trademark of Xerox Corporation. All other product nam ...

WARNING: Do not operate the unit with the end plates removed. WARNING: Properly ground the unit before connecting anything else to the unit. Units not properly grounded may result in a safety risk and could be hazardous and may void t ...

The 105M12 is an unmanaged industrial Ethernet switch providing five Fast Ethernet copper ports in an IP65/IP67 rated enclosure for protection against temporary immersion in water. The switch provides Category-5 compliant 10/100BaseTX connections with IP65/67 rated M12 D-code connectors for high perfo ...

The classification of degrees of protection provided by the enclosures is defined by IEC 60529. Each rating is defined by specific tests. The IP number is comprised of two numbers, the first referring to the protection against solid objects and the second against fluids. The higher the number, the better the d ...

WARNING Never install or work on electrical equipment or cabling during periods of lightning activity. BULKHEAD MOUNTING The following are the mechanical dimensions and drill hole placements to consider when mounting the 105M12 and 108M12 Industrial Ethernet Swi ...

All ports are Auto sensing 10/100BaseTX Connections M12 A-Coded Male Port Redundant Power Input (10-30VDC) Green LED lights when Power is connected LED’s: The table below describes the operating modes: LED Color Description ON Power is Applied. OFF Power is OFF. LNK/ ...

be made only when the male and female ends are lined up properly. When the power is first connected all LED’s will flash ON Momentarily. Verify the Power LED stays ON (GREEN). Note: Either V1 or V2 can be connected to power ...

Drain wire with lug connecting switch chassis to known grounding point. CONNECTING THE UNIT For 10Base-T ports, plug a Category 3 (or greater) twisted pair cable into the M12 connector. For 100Base-T ports, plug a Category 5 (or greater) twisted pair cable into the M12 connector. Connect ...