NAIM NAC 112 - ISSUE 2 Manual 

Text of the manual

W O R L D C L A S S H I F I

O W N E R S M A N U A L Preamplifiers: NAC 552, NAC 252, NAC 282, NAC 202, NAC 112 I S S U E 2

2 Cables and Connections

Please do not modify the standard interconnect cables supplied with your Naim equipment. This is important for safety as well as performance. One end of each cable is marked with a band to establish its correct orientation. The band always marks the end that connects to the signal source. Loudspeaker leads are also very important.

3.3 mains supply

Where fused plugs are used 13 amp fuses should be fitted. Fuses of a lower rating will fail after a period of use. A hi-fi system usually shares a mains circuit with other household equipment some of which can cause distortion of the mains waveform. In some Naim equipment such distortion can lead to a mechanical hum from the transformers.

In some circumstances, depending on where you live and

the earthing arrangements in your home, you may experience radio frequency interference. Controls on broadcasting in some territories allow very high levels of radio frequency radiation and both the choice and exact siting of equipment may be critical. If there is a known problem in your locality it is

6.1 source inputs and record outputs

The input selector buttons arranged along the uppermost bank select the source signal to be routed to the power amplifier and the loudspeakers. Below them, in the lower bank, are a corresponding array of buttons which select the signal to be routed to the preamplifier’s record outputs. These separate source and record

Note: The unity gain feature must be used with care. It

effectively by-passes the NAC 552 volume and balance controls leaving any signal connected to a unity gain input to be passed to the power amplifier and speakers at full volume. In order to reduce the potential for inadvertent mishap, any subsequent modifications to input mapping will automatically di

NAC 552 Connections

7.1 Front 7.2 Rear volume in 1 in 2 in 3 in 4 in 5 in 6 in 8 ch 1 ch 2 signal ground in 9 ch 1 ch 2 NAC 552PS in balance mono source selectors record selectors mute in 7 rc5 control in NAC 552PS in Specifications NAC 552 and NAC 552PS Input sensitivities: 75mV, 47kΩ Overload margins: 40dB (all inputs all audio frequencies) Main output

NAC 552 Connections

7.3 NAC 552 connection to NAC 552PS power supply NAC 552 Burndy 240° 5 to 5 pin DIN Interconnect Cables cable direction marker mains in to stereo power amplifiers to mono or dual mono power amplifiers additional signal output Note For best performance the Burndy and 5 pin DIN cables should be run as close together as possible. NAC 552

8.1 source inputs and record outputs

The input selector buttons arranged along the uppermost bank select the source signal to be routed to the power amplifier and the loudspeakers. Below them, in the lower bank, are a corresponding array of buttons which select the signal to be routed to the preamplifier’s record outputs. These separate source and record

Other Amplifier Manuals