NETGEAR FS728TP-100NAS Software Administration Manual

6-4 Managing Security v1.0, December 2007 • Active – Select the priority in which the system performs authentication with a Radius Server. The system performs authentication initially with the Radius Primary Server, and if it fails, it performs authentication with the Radius Backup Server. The possible values are: – Primary – Defines the RADIUS Primary Server. – Backup – Defines the RADIUS Backup Server. 2. Select the RADIUS server entry. 3. Enter the Host IP Address, Authentication Port, Number of Retries, Ti ...

3-9 Managing System Settings v1.0, December 2007 The Basic PoE Configuration screen contains the following fields: • Power Status – Displays the online power source status. The possible field values are: – On – The power supply unit is functioning. – Off – The power supply unit is not functioning. – Faulty – The power supply unit is functioning, but an error has occurred. For example, a power overload or a short circuit. • Nominal Power – Displays the actual amount of power the device can supply. The f ...

Contents viii v1.0, December 2007 Chapter 5 Configuring QoS Configuring the Basic and Advanced QoS Settings .......................................................5-1 CoS .................................................................................................................................5-1 Basic ........................................................................................................................5-2 Advanced .................................................................................... ...

Getting Started with Switch Management 1-5 v1.0, December 2007 8. Use your web browser to manage your switch. The default password is password. Then use this screen to proceed to management of the switch covered in Chapter 2, “Introduction to the Web Browser Interface”. Network without a DHCP Server This section describes how to set up your switch in a network without a DHCP server, and is divided into the following tasks: • Manually assign network parameters for your switch • Configure the NIC settings on the hos ...