Faria IS0157 Owner's Manual

Electronic Programmable Speedometer IS0157 FA RI A CO RP . U NC AS VIL LE , C T MA DE IN U. S. A. 16 68 -5 0-3 7A MPH 0 50 10 10 20 30 40 50 60 70 80 0 Km/h 20 30 40 ...

Page 2 Maximum Saved Speed Page 2 Setting the Speedometer Page 3 Boot menu Page 3 Service Hours Page 3 Service Distance Page 4 Clear Hours Page 4 Clear Distance Page 4 Program High Axle Page 4 Program Low Axle Page 5 Input Level control for the speed pulse in ...

2. Trip odometer display (resetable) 3. Hour-meter (either rpm or key-on) 4. Service interval for miles or kilometers (reset, clear and disable features) 5. Service interval for hours (reset, clear and disable features) 6. Over-speed indicator (microprocessor output level change at ove ...

down indicating the hour-meter function. The hour-meter cannot be reset. Grounding P1-E thru an oil low pressure switch can stop the hour-meter. If P1-E is not grounded then the hour-meter will run continuously with the key on. To provide a true engine running hour-meter an external low oil pressur ...

range axles. Setting the speedometer There are two major speedometer setting routines. The first is activated during boot-up. If the push-button is pressed and held on when power is first turned on the “boot menu” will be activated. The second menu, the “run menu”, can be ...

will go back to the first digit and repeat. If the push-button is not pressed for 32 seconds the microprocessor will return to normal and will change nothing. This is useful if you’re only here to check when the present service interval will occur. The operator may also turn power off at this point and noth ...

to the nearest 100 th. The rightmost digit will be a “P” to remind the operator that they are in the “Programming” mode. The digit changes and inputs are the same as number 1 (Service Hours) above. Also present is the same option to do nothing for 32 seconds and the microprocessor will reset itself and ...

menu, you must press and release the push-button before four seconds have passed. The menu items will loop continuously. If you want to get out at this point with no changes, stop at the last menu item “donE”, and in four seconds the microprocessor will return to normal with nothing being changed or if you are ...

The operator may even stop and wait, as long as power is not turned off and the measured mile or kilometer is followed as straight as possible, the operator may not turn around and go in the opposite direction. Also for the maximum accuracy, the operator should not enter any off road parking as this would devi ...

Pin A Battery Input Pin B Ground Pin C Over speed signal Pin D External Push-Button grnd Pin E Hourmeter control Pin F Speed Axle 2 speed axle (ground selects low axle, open connection selects high axle) Hourmeter control (ground disables hour-meter) External push button (ground active) Over speed ou ...