Paradyne 9161 Installation Instructions Manual

Text of the manual

9161 Single T1 Network Access Module (NAM)

Installation Instructions Document Number 9161-A2-GN10-20 September 1997 Before You Begin Make sure you have:  An operable T1 network connection  An async (VT100-compatible) terminal emulation  Housing and other associated hardware  Applicable cables Package Checklist Verify that your package contains the

What Does a T1 NAM Do?

The T1 NAM acts as an interface between the T1 digital network and the customer premises equipment, converting signals received from the DTE to bipolar signals that can be transmitted over T1 and Fractional T1 lines. The T1 NAM also provides a DSX-1 drop and insert port to allow DTEs supporting the DS1 signal format to share the netw

Recommended Order of Installation

1. First, install the I/O card. 2. Connect all cables into the I/O card. 3. Install the NAM. 4. Go to the 2-Slot Housing Installation Instructions (Document No. 9000-A2-GN15), 5-Slot Housing with AC Power Supply Installation Instructions (Document No. 9000-A2-GN16), or 5-Slot Housing with DC Power Supply Installation Instr

Installing the I/O Card

The NAM’s I/O card provides the COM port, network, DSX and DTE connections. The I/O card inserts directly behind the NAM that it supports. Slot numbers are identical (in this case, Slot 01) to facilitate correct installat

Connecting to the Network

1. Insert the 8-pin connector on the RJ48C network cable into the NET interface. 2. Insert the other end of the cable into the RJ48C modular jack. Connecting to a DTE If the DTE cable type is V.35, RS449, o

Connecting to the DSX

1. Insert the DB15 end of the DSX cable into the DSX interface. 2. Insert the other end of the cable into the CPE (Customer Premises Equipment, such as a PBX). Connecting the COM Port to a User Interface 1. Insert the 8-pin end of the cable into the COM port. 2. Insert the other end of the cable into the user interface (VT100-compatib

Installing the T1 NAM

! WARNING: Do NOT remove any jumpers located on the battery. To do so can cause non-volatile memory loss. Should a jumper become separated from the battery, contact your service representative immediately. ! HANDLING PRECAUTIONS FOR STATIC-SENSITIVE DEVICES This product is designed to protect sensitive components from damag

Slide into the tracks until the NAM seats with the midplane connectors. Be careful

not to force the card or bend any pins. 5. Close both the upper and lower ejector latches on the housing to lock in place, then tighten the captive screws on the ejector latches. 6. Replace the housing’s bezel, if applicable. Removing/Replacing a Card Card removal proce

Removing/Replacing the I/O Card

1. Remove the NAM from the housing (see Removing/Replacing the NAM). 2. Remove the network, DSX-1, DTE, and COM port cables from the I/O card (if applicable). 3. Using a screwdriver, loosen the upper and lower screws fastening the card to the housing’s frame. 4. Gently pull the I/O card away from the midplane until it clea

Other Other Manuals