Winegard RM-EX02 Instructions Manual

with Digital Elevation Sensor Model RM-EX02 Made in U.S.A. Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www. winegard.com Printed in U.S.A. © Winegard Company 2009 2452168 REV6 12/12 ...

your antenna for the best signal strength. SLOWLY move the antenna left, then right, until you have found the position that gives the highest signal strength. It is important to turn the antenna slowly. Because the signal is digital, the receiver takes a few seconds to loc ...

Screwdrivers (Phillips and slot) 1-3/4” hole saw 7/16” wrench ABS glue Drill with 1/8” bit Tape measure Non-hardening sealant (Check manufacturer’s specifications for compatibility with your roof material.) Winegard’s Digital Elevation Sensor has been INSTALLED and CALIBRATED at the factory STEP 1. Choose a location on the r ...

than 6-1/2”. Parts Needed: (not included) RP-4400 14” worm gear for roof 3200369 Directional handle extension 2162031 Long threaded rod Instructions: STEP 8. Place nut on threaded rod. See Figure 8. STEP 9. Measure and cut the threaded rod with a hacksaw. Use ...

STEP 15. The directional handle and threaded rod will fit roofs up to 5-1/4” thick. If you are using wedges to compensate for roof/cceiling slope, be sure to allow for this extra thickness. You may add an extension to the directional handle for thicker roofs. Each extension will increase the length of the directional handle by ...

OF VEHICLE  Roof Template 1/8” DRILL BIT 8 HOLES. DO NOT DRILL THROUGH CEILING. 1-3/4” DIA. DRILL COMPLETELY THROUGH CEILING  ...

the antenna SHOULD ROTATE APPROXIMATELY 360° FROM TRAVEL POSITION. The pointer on the DIRECTIONAL HANDLE should point towards the RED SCREW ON THE ROTATION CLAMP when in the TRAVEL POSITION. FIGURE 14 FIGURE 15 FIGURE 16 POINT TO BACK OF RV Pointer mu ...

alkaline batteries should last 88 days. STEP 19. See Figure 17. If using the SM-1000 surface mount box, feed cable through hole in box. STEP 20. Connect wires coming from sensor on roof to wall plate display in vehicle. It is important to properly connect the wires at the roof and the wall plate ...

(4) Flat Head Bolts Back-up Frame Pivot Bracket Pin, 1/4 x 3.25” long (Not Shown: E-clip for 1/4” Pin Travel Support LNBF LB-6000 Carriage Bolt (not shown) Flange Nut 1/4-20 Roller Hex Head Bolt 1/4-20 x 2.5” Nylock Nut 1/4-20 (not shown) Screw #10-24 x 3/4 (4) Clamp (2) (2) #10-32 x 1/2” Screw (2) #10 ...