Oreck compact canister Vaccum Operation & User’s Manual

Text of Oreck compact canister Vaccum Operation & User’s Manual

72150-02 REV C

S I M P L Y A M A Z I N G ® F R A N Ç A I S GUIDE D’UTILISATION PAGE 8 E S P A Ñ O L GUIA DEL USUARIO PAGE 16 USER’S GUIDE COMPACT CANISTER VACUUMS •IMPORTANT• SAVE THIS BOOKLET! Includes: • Safety Warnings • Parts List • Operating Instructions • Maintenance • Warranty • Trouble Diagnosis • Accessories List USA: 1-800-989-3535 CANADA: 1-888-676-7 COMMERCIAL: 1-800-2 �www.oreck.com� www.oreckcommercia � VISIT

CLEANER, READ ALL

INSTRUCTIONS IN THIS MANUAL CAREFULLY. Safeguards, Important Safety Instructions . . . . . . . page 1 Warranty . . . . . . . . . . . . . . page 2 Accessory Parts List . . . . . . . page 3 Operating . . . . . . . . . . . . . page 4 Assembly Instructions . . . . . page 5 Maintenance & Customer Service . . . . . . . . . . . . . . . page 6 Troubleshooting Guide, Accessories . . . . . . . . . . . page 7 Fran

working as it should, has been

dropped, damaged, left outdoors, or dropped into water, return it to a service center or call customer service. Commercial 1-800-989-3535 Canada 1-888-676-7325 • Do not pull or carry by cord, use cord as a handle, close door on cord, or pull cord around sharp edges or corners. Do not run appli- ance over cord. Keep cord away from heated surfaces. • Do not unplug by pulling on cord. To unplug, grasp the plug,

ORECK’s liability for damages to you for

any costs whatsoever arising out of this statement of limited warranty shall be limited to the amount paid for this product at the time of original purchase, and ORECK shall not be liable for any direct, indirect, consequential or incidental damages arising out of the use or inability to use this product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so

Insert end of shoulder strap into slot in

front of on/off power switch. Pull through three to four inches and insert into plastic clip. One inch of strap must be completely through clip. Insert other end of strap through slot located at back of handle. Insert end into clip and pull through. Adjust length by pulling strap through clip. Strap must go through both front and back clips. IMPORTANT: Before using shoulder s

The blower port is located at the rear

of the machine. Installation of tools is the same as described for suction port. Blower Port Cord Dump Twist cord dump to easily release stored cord. Plug cord into electrical outlet. Power Switch Push power switch to “ON” (I) position. Assembly Attach Caddy and Insert Tools Locate caddy clip indents at top rear corners of appliance. Place appliance on firm, non-slip surface or hold in yo

Oreck Vacuum Cleaner Owners Instructions: