Oreck Graphite Operation & User’s Manual
Text of Oreck Graphite Operation & User’s Manual
Read all instructions carefully, and keep for future reference.
Graphite
™
U4305H2BS
IMPORTANT SAFETY INSTRUCTIONS!
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER
WARNING To reduce the risk of fire, electric shock, or injury:
•� Do�not�leave�appliance�unattended�when�plugged�in.�Unplug�from�outlet�when�not�in�use�and�before�servicing.
•� Do�not�use�outdoo
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
General Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
�
Assembling the Handle Tube
Up-Position Lock - Place�foot�on�power�head�and�lean�handle�back�gently�to�release�lock�for�vacuum�use.�
Return handle to the full upright position to engage lock. Note: Do not operate the unit while in the upright and
locked�position.�Do�not�let�the�unit�run�while�in�any�one�stationary�position�for�any�period�of�time.��
�
Keep�the�unit�
Simple Operation Tips and Vacuum Care
This�new�ORECK�Upright�is�one�of�the�finest,�fastest,�and�strongest�units�in�its�class.�You’ll�love�the�way�it�cleans,
gets under things, and it’s SO lightweight and easy to use.
The�following�are�a�few�simple�suggestions�regarding�its�operation:
1.�When�inserting�a�new�HEPA�Filtration�Odour�Fighting�Bag�-FIRST�PUFF�
6
E
N
G
L
I
S
H
WARNING:�Unplug�cord�from�electrical�outlet�before�servicing.
Remove�the�replacement�belt�from�the�storage�channel.
Remove�the�door�by�removing�the�phillips�head�screw�located�on�side�of�power�head.
Fold�door�away�from�the�power�head�and�lift�it�away.
Remove�the�belt�from�the�motor�drive�shaft�and�brush�roll�pulley.
Loop�the�new�belt�ov
baseplate, brushroll should be adjusted.
Remove�the�baseplate�by�removing�5�screws.�Then,�remove�the�belt�and�brushroll�from�the�housing.
Rotate�both�bear