Osburn 2400 Owner's Manual

45111A Printed in Canada 11-06-2014 OWNER`S MANUAL 2400 MODEL INSERT US ENVIRONMENTAL PROTECTION AGENCY PHASE II CERTIFIED WOOD INSERT Verified and tested following ULC S628 and UL 1482 Standards by: Manufactured by: STOVE BUILDER INTERNATIONAL INC.. 250, rue de Copenhague, Saint-Augustin-de-Desmaures (Quebec) G3A 2H3 ...

congratulates you on your purchase and wishes to help you get maximum satisfaction from your wood stove. In the pages that follow, we will give you advice on wood heating and controlled combustion as well as technical specifications regarding installation, o ...

1.0 PRE-INSTALLATION REQUIREMENTS ................................................................................... 3 1.1 MASONRY FIREPLACE REQUIREMENTS ............................................................................................ 3 1.2 VENTING REQUIREMENTS ................................................................. ...

1.1 Masonry fireplace requirements The masonry fireplace must meet the minimum code requirements, or NFPA 211 or the equivalent for a safe installation. Contact your local Building Inspector for requirements in your area. An inspection of the fireplace should include the following: 1. CONDITION OF THE FIREPLACE AND CHIMN ...

The flue is a critical component to a satisfactory installation. Your insert will attain its best performance if installed with a flue that generates its own draft. The minimum venting requirement will be the installation of a flue connector from the insert into the first tile of the chimney. If you are using a masonry chimney, ...

In order to complete the assembly of your Osburn 2400 wood insert, you need to install the door overlay. See figure 1 below for installation instructions: Figure 1 1- Position the overlay on the door frame and fix it in place from behind using the 4 screws. Note: It is not necessary to remove the glass or any other component ...

NOTE: THIS APPLIANCE IS NOT RECOMMENDED FOR USE IN A HOME IF AN OCCUPANT HAS ANY RESPIRATORY OR ANY OTHER RELATED PROBLEMS. 1. It is important to follow the installation and operation instructions. An improperly installed or operated insert could result in a safety hazard or fire, or damage to the unit, which would ...

Inspect the masonry fireplace according to the safety information and fireplace requirements and have it cleaned and/or upgraded as necessary. 2.3 Compliance of the masonry fireplace Where the masonry fireplace opening is 6 ft2 (0.56 m2) or larger, the hearth extension shall extend at least 20'' (508 mm) in front of the facing ...

If the fireplace's draft control system is to remain in the masonry fireplace, it must be locked open for access of the chimney liner or removed entirely. If you remove draft control system from the masonry hearth, you will need to install the metal plate (27009), supplied with the owner’s manual kit, indi ...

In addition to ensuring compliance of the masonry fireplace hearth extension (see Compliance of the masonry fireplace in Section 2.3), it is necessary to have a floor protection made of non- combustible materials that meets the measurements specified in table FLOOR PROTECTION (see Section 2.7). To determine the need to add a floor ...