Outlaw Model 7075 Owner's Manual

Please Read First CAUTION: To reduce the risk of electric shock, do not remove the cover (or back). No user serviceable parts inside. Refer to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. The lightning flash with arrowhead, withi ...

Owner’s Manual Table of Contents 2 Please Read First 3 Table of Contents 3 Model 7075 Seven-Channel Amplifier 3 Features 3 Unpacking 5 Connecting Your Amplifier 5 Input Connections 5 Speaker Connections 6 Model 7075 Rear Panel Connections 7 Power Control Connections 7 Power Connection 7 Amplifier Operation 7 Manua ...

Use the INPUT jacks to connect to the outputs of a surround processor, preamplifier, AV receiver with preout connections, DVD player with discrete five channel outputs, or HDTV product with built-in surround decoder. (see page 5) B Remote Trigger Input Use the REMOTE TRIGGER jack to connect to a compatible proc ...

Owner’s Manual Connecting Your Amplifier Connecting Your Amplifier When making connections between any source components and the ampli- fier, or when making connections to any speaker, be certain that both the input devices and the amplifier are turned off. To assure that there will be no unwanted signal transient ...

Model 7075 Rear Panel Connections ...

Owner’s Manual Amplifier Operation Power Control Connections The Outlaw 7075 features a built-in remote turn-on system that will automati- cally switch the amplifier when another device in the system is switched on. Remote Turn-On Using Products Equipped With a 12 Volt Trigger Jack Press the front panel power swit ...

Master Power Switch turned off (No power light LED) Turn on Master Power Switch Amplifier will not turn on Remote trigger cable not properly connected Verify connection of trigger cable at both ends Amplifier turns on, but no audio from one or more channels Inp ...

Owner’s Manual A Few Words About Hum and Noise Potential Ground Loops in a Complex A/V System Suggestion #1 To determine if a cable TV connection is responsible for the hum, first turn all components off. Disconnect the cable TV feed to your system at the first place where it connects to your components. Alternati ...

Power Output 75 watts RMS x 7 (all channels driven simultaneously into 8 ohms from 20Hz to 20kHz with less than 0.05% total harmonic distortion). 115 watts RMS x 7 @ 4 ohms Frequency Response 20Hz -20kHz +/- 0.1 dB at rated output Total Harmonic Distortion (THD) Less than.05% at rated output, all fre ...