HP DesignJet 4500 Hardware Installation Manual

Hewlett-Packard Company printed in Japan www.hp.com/go/ljsupplies C4197-90903 *C4197-90903* *C4197-90903* A5 BACK COVER A5 FRONT COVER hp color LaserJet series/séries 4500 • 4550 C4197A fuser kit ensemble de fusion lea esto primero installation guide and warranty manual d’installation et garantie ...

two air filters, and a hand wipe. Replace the fuser kit when the printer control panel displays: FUSER LIFE OUT REPLACE KIT. Turn the printer off. Wait 10 minutes for the fans to stop running, and unplug the power cord. Then wait 30 minutes for the printer to cool. Dansk Dette sæt indeholder en fikser ...

see step 5. Otherwise, skip to step 6. Open the rear cover of the duplex printing accessory. Open the upper rear door of the printer. Hvis printeren har duplexudskrivningsudstyr, se da trin 5. Gå ellers videre med trin 6. Åbn det bageste dæksel på duplexudskrivningsudstyret. Åbn den øverste bageste låge ...

squeezing the latches on the straps where they connect to the rear door. Then lower the door. WARNING! To prevent possible burns, be sure the power cord is unplugged and that the printer has cooled for 30 minutes. Inside the back of the printer, near the bottom, locate the two blue latches on the fuser. Dansk ...

degrees. Grasp the finger holds on the fuser and pull the used fuser out of the printer. Remove the new fuser from the bag. Place the used fuser in the bag for recycling. Drej de to blå spænder opad 90 grader. Tag fat i fingerholdepunkterne på fikseringsenheden og træk den brugte fikseringsenhed ud af printeren. Tag ...

slide the fuser into the printer. Lock the fuser in place by rotating the two blue latches down. Remove the two used air filters from the rear of the printer. Then use the hand wipe to clean the fan areas. Dansk Idet du holder den nye fikseringsenhed i fingerholdepunkterne, lader du fikseringsenheden glide i ...

Place the used air filters in the bag for recycling. Insert the new air filters. Reconnect the support straps to the upper rear door. Tag de nye luftfiltre ud af posen. Anbring de brugte luftfiltre i posen, således at de kan sendes til genbrug. Isæt de nye luftfiltre. Forbind igen støttestropperne på den øverste ...

duplex printing accessory is installed, close the accessory’s rear cover. Locate the paper roller for inside the printer. The pattern and shape on the end of it is different from the other three paper rollers. From the front of the printer, pull out Tray 2. Dansk Luk den øverste bageste låge på prin ...

paper roller in the top of the tray cavity. Squeeze the tabs on the roller and remove the old paper roller from the tray cavity. Install the new paper roller in the tray cavity by sliding it onto the spindle until the roller clicks into place. Inde i bakkeåbningen på printeren finder du papirvalsen øverst ...

hub and the cover next to the roller. Squeeze the cover release lever and open the cover. Remove the old paper roller from Tray 2 by squeezing together the blue tabs and then sliding the roller off its spindle. Dansk På bakke 2 finder du papirvalsen med en blå muffe og dækslet ved siden af valsen. Kle ...