GE JX82 Installation Instructions

Text of GE JX82 Installation Instructions

BEFORE YOU BEGIN

1 Installation Microwave Oven Instructions Built-In Trim Kits Read these instructions completely and carefully. • IMPORTANT – Save these instructions for local inspector’s use. • IMPORTANT – Observe all governing codes and ordinances. • Note to Installer – Be sure to leave these instructions with the Consumer. • Note to Consumer – Keep these instructions for future reference. • Skill level – Installation of this appl

1 Ft = 0.3 m

1” = 2.5 cm 2 TOOLS YOU WILL NEED Pencil Knife Tape Measure Level 2 Phillips Screwdrivers (#1 & #2) Drill with 3/32” Bit Centerpunch or Nail LOCATE AND INSTALL THE REAR HOLDDOWN SUPPORTS Set base pan into the front cabinet microwave oven cutout and center it right and left. Push back until the front flange is against the cabinet front wall. Using the V-notch in the base pan front flange, mark the location of the V

INSTALL THE BASE PAN

Disconnect the microwave oven from the receptacle. Remove everything out of the microwave oven, including packing, temperature probe, Owner’s Manuals, turntable and turntable support. Remove the two top plug buttons from the top of the microwave oven cabinet. Use a knife to pry up the plug buttons, using care not to scratch the microwave oven. A clear protective film has been applied to some microwave oven
1 Ft = 0.3 m 1” = 2.5 cm CHECK LEVELING Check the leveling by placing a level at the front and sides of the microwave. It may be necessary to add wood shims under the bottom duct to level the microwave front-to-back or side-to-side. 7 INSTALL THE BOTTOM BRACKET Install by placing the bottom bracket on the front of the base pan and flush with the bottom of the oven. Align the two screw holes, and drive two screws (D) through th

GE Microwave Oven Owners Instructions: