Promise Technology C6101SSWP000000-2 Product Manual

this manual may be reproduced or transmitted in any form without the expressed, written permission of Promise. Trademarks All trademarks are the property of their respective holders. Important data protection information You should back up all data before installing any drive ...

Introduction............................................................................... 1 Specifications ____________________________________ 1 Interface...................................................................................................................1 Housing Assembly .............................. ...

drive housing installs easily into any 5.25” component bay in your PC. SuperSwap’ s drive carrier and housing extend the data storage capabilities of your system by allowing you to easily swap most 3.5” form factor ATA hard drives in and out of y ...

Drive Types • Supports standard IDE drives (Ultra ATA, DMA, and EIDE) • Supports Ultra ATA/100 and Ultra ATA/66. ATA RAID “Hot Swap” Support • Supports Promise ATA RAID products allowing “ hot swap” under RAID 1, 3, or 5 • Hot swap allows for easy repair ...

your personal computer. Please read through this chapter carefully before attempting to install SuperSwap. As a standard precaution when working with hard drives, users should backup any hard drives containing data that may be connected to SuperSwap be ...

Installing SuperSwap into your PC is a simple process. There are two basic components involved: installing the housing assembly in your system; and installing a hard drive in the drive carrier. Make sure that you’ re properly grounded when installing SuperSwap, either by touching a grounded portion of yo ...

Figure 2-2: SuperSwap Housing Assembly Rearview NOTE: If using the SuperSwap solely as a SLAVE device, make certain to connect the end of the IDE Cable (not to the middle) to the SuperSwap Chassis. HDD Cable Connection Power Connector Fan Key Lock LEDs Pivoting Door Assembly Screw Mounting Holes (2 on ...

controllers that can support RAID 1 (SuperTrak100/66, FastTrak100/66), RAID 3 (SuperTrak100/66), or RAID 5 (SuperTrak100/66). Used with these products and RAID levels, the SuperSwap supports “ hot swapping” of hard drives (meaning you ca ...

the drive housing assembly and the matching numbered sticker on the front of the drive carrier. Figure 2-3: Drive Carrier Assembly LED Messages This section provides information on how to interpret LED display codes as reported by the SuperSwap3 when connected t ...