Sun Microsystems SUN BLADE 150 Installation Manual

4150 Network Circle Santa Clara, CA 95054 U.S.A. 650-960-1300 Send comments about this document to: [email protected] Sun Blade™150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide Part No. 816-5369-10 June 2002, Revision A ...

Sun Microsystems, Inc. has intellectual property rights relating to technology embodied in the product that is described in this document. In particular, and without limitation, these intellectual property rights may include o ...

1 Required Tools 1 Preparing to Replace Components 2 Powering Off the System 2 Removing the System Cover 3 Attaching the Antistatic Wrist Strap 4 Removing a Primary Hard Drive 5 Replacing a Primary Hard Drive 7 Installing a Secondary Hard Drive 8 Removing a CD-ROM or DVD-ROM Drive 11 Rep ...

Cleaning a CD or DVD 16 Handling and Storing CDs and DVDs 16 ...

DVD-ROM, and Hard Drive Installation This guide provides instructions for installing a CD-ROM, DVD-ROM, or hard drive in your Sun Blade 150™system. Required Tools The following tools are required to service the Sun Blade 150 system: I No. 2 Phillips screwdriver (magnetized tip suggested) I Antistatic wrist strap I Antistatic mat Pla ...

Preparing to Replace Components Follow these procedures to ensure that you safely save data and power off the system. Powering Off the System Caution – Exit from the operating system before turning off system power. Failure to do so may result in data loss. 1. Back up system f ...

3 2. Verify the following: I The front panel power-indicator LED is off. I The system fans are not spinning. 3. Turn off the power to the monitor and any peripheral equipment. 4. Disconnect cables to any peripheral equipment. Caution – Pressing the power switch does not remove all power from the sy ...

FIGURE 2 Removing the System Cover Attaching the Antistatic Wrist Strap 1. Unwrap the first two folds of the wrist strap. Wrap the adhesive side firmly against your wrist. 2. Peel the liner from the copper foil at the opposite end of the wrist strap. 3. Attach the copper end of ...

5 FIGURE 3 Attaching the Wrist Strap to the Chassis Removing a Primary Hard Drive 1. Power off the system, remove the system cover, and attach an antistatic wrist strap as described in “Preparing to Replace Components” on page 2. Caution – Use proper ESD grounding techniques when handling compo ...

8. Lift the hard drive tray from the hard drive. FIGURE 4 Removing and Replacing a Primary Hard Drive 1 2 3 4 CD/DVD-ROM drive IDE 1 (J504) IDE cable connector ...