Superior SSDV-3328 Installation Instructions Manual

Text of the manual

P/N 700,043M REV. a 06/2008

DIRECT VENT GAS FIREPLACE HEATERS DIRECT VENT SSDV-3328 SERIES SSDVT-3328CNM SSDVR-3328CNM A French manual is available upon request. Order P/N 700,043CF Ce manuel d’installation est disponible en francais, simplement en faire la demande. Numéro de la piè

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

TABLE OF CONTENTS Packaging..........................................Page 2 Introduction.......................................Page 2 General Information...........................Page 2 Requirements for the Commonwealth of Massachusetts..Page 4 New York City Approval......................Page 4 Cold Cli

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

These appliances and their individual shut-off valves must be disconnected from the gas supply piping system during any pressure testing of that system at pressures greater than 1/2 psig (3.5 kPa). These appliances must be isolated from the gas supply piping system (by closing their individual manual shut-off va

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

NEW YORK CITY, NY AND MASSA- CHUSETTS REQUIREMENTS These appliances are approved for instal- lation in the following USA locations listed in the following: Massachusetts - Installation of these fireplaces are ap- proved for installation in the US state of Massachusetts if the following additional requirements

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Cold Climate Insulation For cold climate installations, seal all cracks around the appliance with noncombustible material and wherever cold air could enter the room. It is especially important to insulate outside chase cavity between studs and under floor on which the appliance rests, if floor is above ground le

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Figure 4 - Typical Locations MANUFACTURED HOME REQUIREMENTS This appliance may be installed in an after- market permanently located, manufactured home (USA only) or mobile home, where not prohibited by local codes. Cet appareil peut être installé dans un maison préfabriquée (É.-U. seulement) ou mobile déj

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

The vent / air intake termination clearances above the high side of an angled roof is as shown in the following chart: 12 X Roof Pitch is X/12 2 FT MIN. 2 FT MIN. Lowest Discharge Opening H* *H = MINIMUM HEIGHT FROM ROOF TO LOWEST DISCHARGE OPENING OF VENT TERMINATION HEIGHTS FOR VENTS ABOVE FLAT OR SLOPED ROOFS

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Figure 7 V V V V V F C Fixed Closed Window Operable Window B B A B H M I = Area where Termination is not Permitted = Air Supply Inlet X = Vent Termination V D V 3 ft. 3 ft. A A A = 9 in U.S. = 12 in Canada V L B J X V A G Inside Corner Detail B C C C *18 Ventilated Soffit Horizontal Termination Detail D Exteri

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Combustible materials may project beyond the sides of the fire- place opening as long as they are kept within the shaded areas illustrated here. Hearth Extension - A hearth extension is not required with this appliance. If a hearth extension is used, do not block the lower control compartment door. Any hearth e

Other Ventilation Hood Manuals