ECX Revenge ECX04000 Type E Instruction Manual

1/8 Electric buggy ECX04000 Congratulations on your purchase of the ECX® Revenge Type e™ Buggy. This 1/8-scale model introduces you to the sport of RC driving. Herzlichen Glückwunsch zum Kauf des ECX Revenge Type e Buggy. Dieses 1/8 Scale Model öffnet Ihnen die Welt des ...

For up-to-date product literature, visit http://www.horizonhobby.com and click on the support tab for this product. WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before ope ...

Your new Horizon Hobby vehicle has been designed and built with a combination of waterproof and water-resistant components to allow you to operate the product in many “wet conditions”, including puddles, creeks, wet grass, snow and even rain. While the entire vehicle is highly water-resistant, it i ...

Battery AA x 4 Servo Power Supply 4.8V~6V (shared with receiver) Output Torque 199.8 oz-in (8.5 kg-cm) Operating Speed 0.20 sec/60 degrees of travel Size 55.6 x 18 x 30mm Electronic Speed Control (ESC) Input Voltage 7.4–11.1V Constant/Peak 100 A/590 A Resistance 0.0045 Ohm Overload Protection T ...

1. Remove the long wing clip from the wing mounts. 2. Align the holes in the wing with the wing mounts. 3. Press the wing onto the wing mounts. 4. Secure the wing by sliding the long wing clip through the wing mounts. INSTALLING THE BATTERY IN THE VEHICLE removing/Installing THE VEHICLE BODY Removing 1. Remove the two body clips. ...

the direction of steering (ST. REV) and throttle (TH. REV) controls. (Default settings are “R” for steering and “N” for throttle) BIND TH ST N R N R Adjusts the neutral point of the electronic speed control ...

3. Do a test of the transmitter’s control of the vehicle with the vehicle’s wheels off the ground. POWER ST. TRIM TH. TRIM ST. RATE 1. Power on the transmitter. • ALWAYS turn on your transmitter before you turn on the receiver in the vehicle. Always power off the receiver before turning y ...

• Prolong motor life by preventing overheating conditions. Undue motor wear results from frequent turns, stops and starts, pushing objects, driving in deep sand and tall grass, and driving continuously up hill. • Over-temperature protection is installed on the ESC to prevent circuit damage, but cannot protect the motor from d ...

The ESC comes preset from the factory. It will need to be recalibrated whenever changing to a different transmitter. ESC Calibration Procedure Ensure proper ESC function by calibrating the ESC to your transmitter inputs. 1. Power off the ESC. 2. Ensure your transmitter is powered on, the throttle is not reversed, throttl ...

• Examine your vehicle on a regular basis. • Use a brush to remove dirt and dust. • Look for damage to the suspension arms around other molded parts. • Re-glue the tires to the wheels, if necessary. • Use suitable tools to check and tighten fasteners. • Make sure the camber and steering linkages are not bent. Rep ...