Beam iridium SatDOCK 9555 Installation & User Manual

Beam Communications, a wholly owned subsidiary of World Reach Limited (WRR), listed on the Australian Stock Exchange, is a world leader in design, manufacture and distribution of specialized communications equipment for the Iridium Satellite Network. Beam’s commitment to be at the forefront has continued to increase its share of the global satellite communications market. Its premium distribution network spans the world. Recognized as a leading provider of satellite communication solutions, Beam specializes in Voice, Data, Tracking and customized s ...

Q You can’t make international calls A Have you included the relevant codes? Press and hold the (+) key to display the international dialling prefix (+), and then enter the appropriate country code, followed by the phone number. Q Your PIN2 is locked A Enter the PIN2 unblocking key (PUK2) or contact your service provider. Q You can’t cancel call forwarding or call barring A Wait until you are in an area with good network coverage and try again Q Your SIM card won’t work A Is the card inserted the correct way? Is the gold chip visibly damaged or ...

1. Using the Hands Free Interface as a template, mark the hole locations. 2. Remove the bracket, and use an awl or similar device to start the holes at the marked locations. 3. Drill the holes & mount the HFI unit using six suitable screws. Using the Connector Plugs The connector plugs can be removed from the Hands Free Interface for easy wiring and then connected once completed. The screw connector enables the cables to be securely fastened. Ensure that no wires are exposed once the screw is fastened to avoid blowing a fuse. The cables should ...

Warnings, cautions and notes appear throughout this manual and are represented by following conventions. WARNING / CAUTION: This symbol and associated text indicate a warning note providing information to prevent damage to equipment or personal injury. NOTE / IMPORTANT / TIP: This symbol and associated text indicate a note providing general operating information. INTERFERENCE: All wireless phones may get interference, which could affect performance. RECORD: Write details of your unit for easy reference when required. Ideal when troubleshooting. ...

vehicles’ existing communications system. The Line audio level of this interface is that of typical equipment being -10dBV, which is about 0.3V RMS (2V Peak to Peak Max) Input Impedance: 50k ohm Output Impedance: 1.2k ohm Pinout: 1 (left) = Line In (uplink audio) 2 (middle) = ground 3.(right) = Line Out (downlink audio) USING THE LINE IN/OUT Line In/Out NOTE: It is recommended to use screened 2-core audio cable. It may be required to adjust the gains of the communications system that is being interfaced in order to achiev ...

The Hands-free interface is capable of supporting the use of an optional Intelligent handset. An optional Beam RST970 Intelligent Handset will simply connect to the Hands Free Interface Unit. When connecting the RST970 Intelligent Handset, make sure that the Vehicle Accessories is off and the 9555 handset is off prior to powering on the Intelligent Handset. Refer to the RST970 Intelligent Handset manual for more information. CONNECTING AN INTELLIGENT HANDSET (OPTIONAL) NOTE: Only an approved Beam DPL Based Iridium Intelligent Hand- set should be insta ...