Flex-a-Lite 330 Installation Instructions

Thermostatic Control and A/C Relay Part #330 Setting Pull or Push Configuration: At the factory, the model 330 is assembled to pull air. To push air, remove the clips that hold the fan blades onto the motor shaft and turn the fan blade over. Reinstall the clips to the motor shafts. Important: See wiring diagram (next page), correct w ...

Locate a mounting point for control near inlet side of radiator. The control needs to be placed within 18" of radiator inlet hose. You may want to mount next to radiator on fender well. Mount the control using the screws provided. Step 2: Wire the fan motors (refer to wiring diagram, below) Using the yellow butt co ...

shown on the wiring diagram (previous page). Connect the "M" terminal on the control module to the "#1" terminal on the switch. Connect the "#2" terminal on the switch to a positive 12v power source. Connect terminal "#3" on the switch to a good ground (for s ...