Centurion R3 Installation Manual
Text of the manual
Centurion Systems (Pty) Ltd. reserves the right to make changes to the products described in this manual without notice and without
obligation of Centurion Systems (Pty) Ltd. to notify any persons of any such revisions or changes. Additionally, Centurion Systems (Pty) Ltd.
makes no representations or warranties with respect to this manual.
No part of
Table of Contents
Table of Contents
Declaration of Conformity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Fast Track
. . . . . . . . . .
Declaration of Conformity
Declaration of Conformity
Page 4
Manufacturer:
Centurion Systems (Pty) Ltd
148 Epsom Road
North Riding
Gauteng
South Africa
Declares that the product:
Product Name:
R3 Swing Gate Operator
Product Options:
All variants
Conforms with the following specifications:
Safety:
IEC 60355-1:1991 & Am1:1994 & Am2:1999
Emissions:
CISPR 22 CLASS
Important Safety Instructions
Important Safety Instructions
To ensure the safety of people, it is important that you read all the
following instructions. Incorrect installation or incorrect use of
the product could cause serious harm to people.
ATTENTION
The installer, being either professional or DIY, is the last person on the site that can ensure that the
These abbreviated instructions are for the experienced installer who needs a checklist to get a
standard installation up and running in the minimum of time.
Detailed installation features and functions are referred to later in this manual.
Fast Track
Fast Track
Action
Mechanical Setup
Read and understand all safety instructions
Page 5
Gather required tools a
The R3 & R5 rotary swing gate systems are designed to open and close swing gates. The CP75 controller
is capable of handling both single and double swing gates and offers many features to suit almost any
application.
Detailed specifications for the R3 & R5 motors are shown in the figure below and the table alongside.
The unit employs a battery driven DC mot
Connect all wiring:
Page 27
Set the gate origin:
Page 27
Release the manual override and close the gate(s)
Use origin tool and line up marks
Open gate ½ way and unscrew the manual release
mechanism.
Get into programming mode:
Page 28
Remove all power.
Fit the SET link.
Reapply power.
Select master or slave set-up:
Page 29
Press and hold TEST, release after
220V AC ±10% 50Hz
AC Current draw (with C84E Battery Charger)
120mA
120mA
DC Motor Voltage
12V
12V
DC Current draw (Max)
30A
35A
Maximum solenoid lock current draw
2A
2A
Output shaft rotational speed
3.5 rpm
2.6 rpm
Maximum output torque
95Nm
250Nm
Mass of master motor kit (excluding pedestal or wall bracket)
14.4kg
15,5kg
The actual components supplied may vary depending on the model purchased.
Product Identification
Product Identification
Figure 2 Linkage Hardware Kit
1
Page 10
1.
R3/R5 Linkage Hardware Kit
2.
Connecting Arm
3.
Drive Arm
4.
End Cap
5.
Drive Arm Clamp
6.
Wedge
7.
M10 Washer
8.
M12x65 Bolt
9. Clevis Pin
10. Gate Bracket
11. Padlock wi