KitchenAid KERS505XSS00 Installation Instructions Manual

INSTRUCTIONSD'INSTALLATIONPOURCUISINIERE ELECTRIQUEAUTOPORTANTEAVEC FOURSDOUBLES Table of Contents Table des mati_res RANGE SAFETY ......................................................................... 1 INSTALLATION REQUIREMENTS ............................................ 2 Tools and Pa ...

A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. INSTALLATIONREQUIREMENTS s :xnd Gather the required tools and parts before starting installatio ...

countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensio ...

Ifcodespermitandaseparate groundwireisused,itis recommended thataqualifiedelectricalinstallerdetermine that thegroundpathandwiregaugeareinaccordance withlocal codes. Donotuseanextension cord. Besurethattheelectricalconnection andwiresizeareadequate andinconformance withtheNationalElectrical Code,ANSI/ NFPA70-latesteditionandalllocalcodesandordinances. Acopyo ...

electrical shock. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate and wire gauge are in accordance with local codes. Be sure that the electrical connection and ...

Failure to do so can result in back or other injury. 1. Remove shipping materials, tape and film from the range. Keep cardboard bottom under range. 2. Remove oven racks and parts package from inside oven. 3. To place range on its back, take 4 cardboard corners ...

bracket that is taped inside the upper Floor Mounting oven with the package containing literature. 2. Determine which mounting method to use: floor or wall. If you have a stone or masonry floor you can use the wall mounting method. 3. Determine and mark edge of range in the cutout space. The mounting bracket can be installed on either ...

Electrical Shock Hazard Disconnect power before servicing. Use a new 40 amp power supply cord. Plug into a grounded outlet. Failure to follow these instructions can result in death, fire, or electrical shock. Direct Wire Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper or 6 gauge aluminum wire. Electrically grou ...

• Use Phillips screwdriver to remove screws and slide cord/conduit plate down and out. f ............... Position cord/conduit plate as shown in the following illustration. • Replace cord/conduit plate and insert screws. • Assemble a UL listed conduit connector in the opening. • Feed the flexible conduit through the ...

• New branch-circuit installations (1996 NEC) • Mobile homes • Recreational vehicles • In an area where local codes prohibit grounding through the neutral 1. Part of metal ground strap must be cut out and removed. 5. Use 3/8"nut driver to connect the neutral (white) wire to the center terminal ...