Heatilator C-40 Installation Manual

performed by qualifi ed personnel. Hearth & Home Technologies recommends NFI certifi ed profes- sionals, or technicians supervised by an NFI certifi ed professional. EPA CERTIFIED WOODBURNING FIREPLACE Fire Risk. WARNING For use with solid wood fuel only. Other fuels may overfi re and generate poison ...

• DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. • NOTICE: Indica ...

C40 Fireplace Install YES IF NO, WHY? Verified that the chase is insulated and sealed. (Pg. 13) Required non-combustible board is installed. (Pg. 15) Verified clearances to combustibles. (Pg. 11) Fireplace is leveled and secured. (Pg. 14) Hearth extension size/height decided. (Pg. 14 & 37) Outside air kit installed. ...

A. Fireplace Certifi cation This fi replace system has been tested and listed in ac- cordance with UL127 and ULC-S610-M87 and (UM)84- HUD standards for installation and operation in the United States and Canada as described in this manual. Check with your local building code agency before you begin your i ...

NOTICE: This fi replace must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/ NFPA 70-latest edition or the Canadian Electric Code CSA C22.1. • A 110-120 VAC circuit for this product must be protected with ground-fault circuit-interrupter protection, ...

Termination Cap Chimney penetrates roof preferably without affecting roof rafters Offset/Return (with hanger straps) Attic insulation shield (not shown) must be used here to keep insulation away from chimney if attic is insulated Storm Collar Framing headed off in ceiling joists Mantel Decorative facing and trim Protective metal hearth stri ...

or projecting into a garage Across a corner Along a wall As a room divider 24 in. (610mm) 24 in. (610mm) 24 in. (610mm) 48 in. (1219mm) 24 in. (610mm) I A Figure 2.2 Fireplace Locations NOTICE: • Illustrations and photos refl ect typical installations and are FOR DESIGN PURPOSES ONLY. • Illustrations/diag ...

Location of the fi replace and chimney will affect perfor- mance. • Install within the warm airspace enclosed by the building envelope. This helps to produce more draft, especially during lighting and die-down of the fi re. • Penetrate the highest part of the roof. This minimizes the effects of wind loading. • Locate t ...

Before beginning the installation be sure the following tools and building supplies are available: Reciprocating saw Framing material Pliers Non-combustible sealant Hammer Gloves Phillips screwdriver Framing square Flat blade screwdriver Electric drill and bits Plumb line Safety glasses Level Tape measure 1/2-3/4 in. length, #6 o ...

A. Fireplace Dimensions 11-1/8 in. (283 mm) 23-1/8 in. (587 mm) 31-1/8 in. (791 mm) 3-1/2 in. (89 mm) 40-5/16 in. (1024 mm) 43-13/16 in. (1100 mm) 37 in. (940 mm) 40 in. (1016 mm) 43 in. (1016 mm) 1 in. (25 mm) 5-7/8 in. (149 mm) 6-1/2 in. (165 mm) 9-11/16 in. (246 mm) Fan Electrical Access (right side of fireplace) Figure 3.1 Firepl ...