DeWalt D28715-XE Instruction Manual

The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING: Indicates a potentially hazardous situation which, if not avoided, co ...

condition. When using and extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord l ...

cutting tool is unintentionally contacted. • CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function — check for alignment of mo ...

• Do not use circular saw blades or any other toothed blades with this tool. Serious injury may result. • Do not operate this tool near flammable liquids, gases or dust. Sparks or hot chips from cutting or arcing motor brushes may ignite combustible materials. • Do not use the side of the abrasive wheel ...

into contact with the tool. Supervision is required when inexperienced operators use this tool. H FIG. 1 L K I G E A N M J D C B F For your convenience and safety, the following warnings are on your Heavy-Duty 355 mm (14") Chop Saw: For safe operation read the Instruction Manual ...

To best deflect sparks away from surrounding persons and materials, loosen the screw (B), adjust the spark deflector (C) and then retighten screw. CAUTION: Risk of property damage. Do not allow cordset to come into contact with deflector or sparks as damage to cordset may occur. Vise Operation (Fig. 4) The vise has a qui ...

The Quick-Change blade clamp requires no tools to change the blade. 1. Push in wheel lock lever (L) and rotate FIG. 7 Q U J S O U P J S wheel (J) by hand until wheel lock lever engages slot in inside flange (S) to lock wheel. Loosen the Quick- Change blade clamp (Q) counterclockwise. Clamp has right- h ...

washer, (Fig. 7, O, P) is available at extra cost from your local dealer or authorized service center. Please call 1 800 654 155 (Aust) or 0800 339258 (NZ) for more information. When using the keyed blade clamp system, do not overtighten bolt. WARNING: Risk of personal injury. Che ...