Oakton 1000 series Operating Instructions Manual

XXXXX-XX OPERATING INSTRUCTIONS OAKTON 1000 series 1⁄4 DIN Conductivity and Resistivity Controllers CAL ENTER ALARM REL A REL A REL B REL A REL B AUTO MANU ESC Conductivity Controller 1000 Series MEAS µS °C ATC 16. Warranty OAKTON warrants this controller to be free from significant deviations in material and workmanship for ...

1. Introduction ................................................................................................................4 2. Assembly and Installation..............................................................................5-10 2.1 Typical measurement and control system......................................................... ...

Conductivity or Resistivity controller. You can use this unit to measure either Conductivity or Resistivity with fast-responding on/off control. This controller has many user-friendly features; some of its features include: Included with your controller Your cont ...

The front panel meets protection class IP 54. Back panel The back panel consists of two different connectors: the 17-way PCB edge connector and the 5-way screw terminal connector. 2.2 2.3 Pt100/ RELAY1 7 6 L N 5 4 PE 100mA (F) FUSE250VAC 11 HOLD ALARM RELAY2 1 2 3 17 17 ...

the controller before wiring input and output connections, and before opening the controller housing. Electrical Connections mA 1 2 3 AC: L N PE 4 5 6 7 8 9 10 11 12 13 14 15 16 17 – + Signal Output Hold Input Alarm Relay 2 Relay 1 Power Mains 1. VAC live wire 2. VAC neutral wire 3. VAC ...

contact closure across terminals 13 and 14. When the HOLD function is activated, the HOLD indicator will appear in the upper left corner of the display (see page 12 for a diagram of display characters). Typical applications: Float or level switch: Connect ...

status messages for easy, quick reference. The display provides short-text informa- tion for configuration and for setting parameters. • The upper (primary) display shows conductivity or resistivity readings • The lower (secondary) display shows temperature readin ...

When you initially connect power to the controller, it will automatically enter Measurement mode. This controller features a large dual display. • The upper display will show the present conductivity (resistivity) value • The lower display will show the temperature value Annunciators along the right side of the display will indicate ...

4.3 To change calibration data, follow these steps: 1. Press the CAL key. The upper display will show “000” and the lower display will show “C.Cd”. See figure 2. Press the L key to scroll the upper dis- play to Calibration security code “11”. See figure 3. Press the ENTER key. NOTE: Press ...

1. Enter Calibration mode. From measure- ment mode, press the CAL key. Press the L key to enter Security code “11”. Press the ENTER key. See figure 2. Press the ENTER key to begin calibra- tion. The upper display will show a per- cent value and the lower display will show CEL (cell). The “CAL” indicator wi ...